Critical Cycles STASH RACK User manual

ASSEMBLY INSTRUCTIONS
STASH RACK PARKING STAND
Your Stash Rack is modular and can be assembled to accommodate as few as one
bike or as many as five bikes by assembling the number of wheel support sections
that are needed.
To assemble the rack start by piecing together the frame tubes (five for each side).
Fit the small end of one tube into the larger end of the next tube by pressing down
on the chrome button and inserting until the button snaps out in the long slot at the
end of the tube. Complete the frame assembly by inserting the frame tubes into
each end of the curved frame tubes ends. (FIG 1)
Assemble the wheel arms by inserting one end into the large hole in the frame tube
and threading a screw on the opposite side through the small hole.
Note: the wheel arms have one side shorter than the other. Make sure you are
assembling them to match each other as well as the other pairs on the frame.
(FIG. 2)
Install the wheel arm binders to the back side of other arms by squeezing the arms
together at the top & then sliding the binders down to the bottom of the arms.
(FIG 3 & 4)
Figure 1
Figure 2
Figure 3 Figure 4
10 FRAME TUBES
PART LIST
10 WHEEL ARMS
2 FRAME TUBE
ENDS
5 WHEEL ARM
BINDERS
20 SCREWS

Warranty:
• For any information regarding Retrospec bicycle warranties please refer to the Westridge Outdoors website:
https://westridgeoutdoors.com/pages/critical-cycles-warranty
Contact:
CRITICAL CYCLES - Customer Service
213 • 744 • 1555
[e-mail]