CSI W60 User manual

Portable Refrigerator
PART #W60
Please read this operating manual carefully before using device.
Keep it in a safe place for future reference.

,

• Do not operate the device if it is visibly damaged.
• Do not block the gaps of the device.
• Do not expose the device to rain or soak it in water.
• Do not place the device near open ames or other heat sources (heaters, direct sunlight,
gas ovens etc.)
• Do not store explosive substances like spray cans with ammable propellants in the device.
• Before starng the device, ensure that the power supply line and the plug are dry.
• Check if the voltage specicaon on the type plate matches that of the energy supply.
• Once unpacked and before turning on, the device must be placed on a level surface
for more than 6 hours.
• Make sure that the device stays horizontal when it is running. The lt angle must be less
than 5° for long term running and be less than 45° for short term running.
• The refrigerator must be well venlated for heat dissipaon and have space for airow
(Back Space> 8”, Side Space> 4”).
• The device may only be repaired by qualied personnel. Improper repairs can lead to
safety hazards. If the power cable is damaged, it must be replaced by the manufacturer,
customer service or a similarly qualied person in order to prevent safety hazards.
• The device can be used by children aged 8 or over, as well as by persons with reduced
physical, sensory or mental capabilies or a lack of experience and/or knowledge,
providing they are supervised or have been taught how to use the device safely and are
aware of the resulng risks.
• Children must be supervised to ensure that they do not play with the device.
• The installaon of DC power in a boat must be handled by qualied electricians.
• Disconnect the device or switch it o when you turn o the engine. Otherwise you may
discharge the baery.

• High-eciency DC compressor and conversion module, with Hi/Lo compressor mode for
energy savings or max cooling.
• CFC free and great heat insulaon.
• Lithium baery recharged by DC12/24V or AC 100-240V (using the adapter).
• Fast cooling to -20°C/-4°F (based on 25°C/77°F room temperature).
• LCD digital display for temperature seng.
• Built-in LED lighng
• Dual compartments with individual temperature control.
• Drain plug in boom for easy clean out.
• Three stage baery protecon system prevents discharged baeries.
• Oponal baery back up.
• Specic parts: wire storage baskets, interior drain plug, oversize wheels and telescoping
handle, detachable baery, lid/door with built-in cup holder, interior LED light.
• Downloadable CSI Black Ice app for smart phones and tablets:
• Shows voltage, temp, and baery condion if connected
• Allows adjustment of temperature, baery protecon, compressor speed, OF or OC, and all sengs
• Can turn on or o via the CSI Black Ice app
• Compable with IOS and Android mobile devices
• To download the CSI Black Ice app:
• Apple phone/tablet: Visit the Apple app store and search CSI Black Ice, download the app to
your phone or tablet
• Android phone/tablet: Visit the Google Play store and search CSI Black Ice, download the app
to your phone or tablet
3.Product Details
Handle release
buon
Compressor compartment
*Removable battery: press left and right to remove/insert the battery.
*Press the handle release buttons on both sides of the telescoping handle at the same time to extend the
handle.

.
,
Fo
it will take a while to reach the set temperature.)

The baery protecon should be set from H to M or from M to L if there is a voltage protecon
code Fl shown on the panel. The baery gear should be set to H (high) if the refrigerator
needs to keep working aer turning o the car engine and to avoid the possibility of overuse
or draining the baery to the point where the vehicle cannot be restarted.
scenarios.
•Factory reset:
The baery protecon mode will protect your car & fridge when the voltage is insucient.
Due to the dierent output voltages between vehicles, H should be set when the product
is connected to car power, and M or L should be set when it is connected to a portable
baery or other back-up baery.
It is not recommended to change other E sengs which are used for factory maintenance.

6.
Open drain at bottom to remove excess liquid.
Open drain in the bottom of fridge.
these steps:
damp cloth to clean the device and dry it.

Verify the power supply is working.
This is normal caused by the ow of refrigerant.
This is normal the moisture will condense to water when
it touches a cold surface of the refrigerator.
This is normal the noise will be reduced aer the compressor
works stably.