CSL DualCom Pro Visonic PowerMaster User manual

DualCom Pro
Visonic PowerMaster
CSL1783V2 21082020
Panel Connection – MCM
Manufacturer Visonic
Model PowerMaster
Version Below
Minimum Panel Firmware
MCM version less or equal to V1.05 - Needs SPT version
less or equal to V2.06
MCM version greater or equal to V1.06 - Needs SPT
version greater or equal to V2.07
Cable required? Standard alarm cable
Panel Profile VISONIC-PMAX/MASTER-MCM
Panel Bus Connection MCM
Technical Notes
Reporting of Pro path states to the panel is not supported
via the serial interface. [Please use the Pro Outputs]
** UPDATE ** UK Panel Firmware V3.3.3 (UK only) - All
tested and working fine on SIA & UDL via the DualCom
Pro
Panel Connection Information
 


Panel Programming

Enable “Installer Access” - Default user code = 1111 > Press the “Unlock Icon” button > Enter
“User Code”
Enter “Engineer Mode” > Press “OK” > Enter “Installer Code”
Enter “Communications Menu” > Press “OK”
Navigate to “C.S. Reporting” > Press “OK” > At “1st RPRT CHAN” > Press “OK” > Select “PSTN”
> Press “OK”
Under “2nd RPRT CHAN” > Press “OK” > Select “Disabled” > Press “OK”
Navigate to “RCVR1 Account” > Press “OK” > Enter “Account Number” (chip number) > Press
“OK”
Go to “PSTN/GSM RCV1” > Press “OK” > Insert a “Telephone Number” (example:
01234567890) > Press “OK”
Navigate to “PSTN Format” > Press “OK” > Select “SIA” > Press “OK” > Press “ESC”
Navigate to “Up/Download” > Press “OK” > Navigate to “PSTN Up/Download” > Press “OK”
Enable “Remote Access”
Press “ESC” button to make the changes take effect




