CTA QPAD-HRSWLT User manual

QPAD-HRSWLT
INSTRUCTION - MANUAL
Height-Adjustable Rolling Workstation Cart
with Laptop Holder
PACKAGE CONTENTS:
INSTRUCTIONS:
A.1pc
E.1pc
C.1pcF.2pcsH.6pcsI.2pcs
G.4pcs
J.1pc
K.4pcsL.1pcM.2pcsO.1pcP.1pc
T.1pc
N.1pc
Q.1pc
M3 wrench
R.1pc
M4 wrench
S.2pcs
M6 wrench
B.1pc
D2.1pc
D1.4pcsD3.4pcsD4.4pcs
M6x12M5x8M5x6
M4x10
3/8" washer
M8 Copper washerM8 washer
M8x35
Open spanner
x1
x1
x1 x1
x1 x1
x1
x1
x4 x4
x4 x6 x2
x1
x4
x1
x2
x1
x4
x1
x1
x1
x1 x1
1. Insert and tighten the wheels 2. Line up and screw in the body
5. Insert and tighten screws
6. Screw in accessories holder
A
H
R
4. Line up tray with body
Insert (6) flat screws
first, then lock each
screw tightly.
C
I
R
D
B
**If necessary, please add nuts and washers
to level the base
F
G
R
E
JL
O
M
N
P
T
M
3. Attach Base Cover
7. Install arm, screws, washers and
accessories as shown
A. Setting up the Floor Stand

B. Attaching Holder to VESA
Rotate screws through VESA from
above as shown while holding hex nuts
from behind with hand until securely
tightened.
**Press lever to adjust height **Detatch the cable tray cover. Align cable to device and along the neck down to
power surge. Replace the cable tray cover as shown.
S
S
**Using provided tool, loosen joint as
shown to adjust arm. Rotate opposite
direction to to tighten once arm is
adjusted to preferred position.
C. Adjusting Floor Stand Height D. How to Cable Route
E. Adjusting Table Arm F. Inserting Laptop
**Sliding open the arms of the plate,
place the laptop in position then release
the holders to grip the laptop in place
**Once laptop holder is connected to the
VESA, you will be able to turn portrait or
landscape for preferred orientation as
well as tilting for preferred angle