CTA PAD-2VDMWA User manual

Dual Acrylic Enclosure Desk Mount
w/ Storage Compartment
PAD-2VDMWA
INSTRUCTION - MANUAL
CONTENTS:
888-733-4448
x1
M5 Allen Key
M5 x 8
M5 Nut
M5 x 12
AD E F
x8 x8 x4 x1
M6 x 16
x4 x4
I K
H
x4
CB
x1
N
M6 Allen Key
J
x1
x4
x4
Flat Head
Star Screw
L
M
G
x2
Rounded Head
Star Screw
Security Star Key
x2
INSTALLATION:
1. Mounting Setup
(x4)
(x4)
M6 Allen key
(x4)
1A. When mounting into a surface for a desk
mount mode, use (4) screws and (4) anchors as
illustrated (H) and rotate through desk mount (A).
Using a screwdriver (not provided), rotate in until
securely tightened as shown above.
1B. When mounting into CTA Digital’s
ADD-PARAFS2 stands, first open the back
door to the storage area. Then use the
provided allen key tool (J) and rotate in
screws (I) on top of the washers (K) as
shown until securely fastened. Shut door
and lock with key. (N)
**Screw Driver is for
illustration purposes and
not included
H
J
I
M6 x 16
K
A
**Floor Stand is for
illustration purposes and
not included
A
Mounting to Direct Surface Mounting to Another
Vesa Compatible Item
OR

888-733-4448
3A. Unlock back storage area using the keys (N). Fish through the holes your
cable as shown into the back storage area. Either ish though the holes at the
bottom if required or even connect to any small charging items, device or
accessories as needed that can fit into the space.
4A.While holding the back security star key (D) tight in place Turn the
front security star key (D) counter clock-wise until all 4 screws (B) are
unscrewed.Then take of front part of enclosure.
4B. Using one of the compatible listed tablets, insert into the
L-shaped adapters for a secure and tight fit.Insert tablet in back
part of enclosure (A) as shown. Watch out orientation of tablet.
G
L
B
4C. Take the detached enclosure top (B), align the corner holes with the bottom portion. Then use the provided
security star key (G), turn in clock-wise the star screws until securely tightened while holding the security star
key (G) on the other side with your other hand. Screw in until securely tightened.
G
B
L
x4
B
F
M5 x 12
C
x4
x1
x4
D
M5 Nut
A
3. Setting up Cable Routing and Access to
Back Storage Area
2. Setting Up Enclosures
2A. Align VESA holes of CTA’s acrylic enclosure (B) with one set of the
desk mount (A) VESA holes in landscape orientation. Using the included
allen key tool (F), rotate in screws (C) while holding hex nut (D) on the
back side until securely tightened. Repeat the process for the other set of
VESA holes and other enclosure.
4. Setting up Acrylic Tablet Enclosures
**Tablets shown are for
illustration purposes and
not included