ICW EV65 User manual

EV65 Wall Mount Installation Instructions
Locate the stud and mark the top hole, drill 11/64
pilot hole and insert #14 screw and tighten slightly.
Using a level, mark the lower hole, drill a pilot hole,
insert #14 screw and with the unit level, tighten both
screws.
NOTE: ICW supplies #14 wood screws. If install-
ing onto metal studs, you will need to replace with
proper metal stud fasteners.
Wall mount assembly
Monitor mount assembly
Securing the wall mount
Securing the monitor mount
Attach the monitor mount assembly to the back of
your monitor, using the 4mm screws provided.
4mm screws
Wood screws
4mm screws
5/16 x 3/4
socket cap screws
5/32 allen wrench
1/4 allen wrench
7/32 allen wrench
Included hardware

5/16 x 3/4
socket cap
screws
Attach monitor mount to wall mount
Detail
Insert stubs on monitor mount into holes
in the mounting bar on the wall mount
assembly. Insert the provided 5/16 x
3/4 socket cap screws in both sides and
tighten. Use the knob under the mount to
adjust the tilt of the monitor.
ev65 wall mount rev. 6/5/07 dw