CTA PAD-HSKSBAE User manual

x1
Rotating Desk Mount with
Acrylic Security VESA Enclosure
PAD-HSKSBAE / PAD-HSKSWAE
INSTALLATION - MANUAL
1A - Align holes at the base (B) with the holes on the base of the body (A). Rotate in screws (G) with tool provided (K) until
securely tightened.
2A - Identify the hole at the bottom of the
base where cable routing should begin.
2. Setting up cable routing :
A
BI
x3
J
x3
x4
F
M5 x 12
x3
G
M5 x 8
x4
H
M5 Nut
x3
G
M5 x 8
K
M5 Allen Key
A
B
2B - Fish the cord from
the base, through the
body and out the top
opening as shown.
2C - Take the the cord at
the base and route it out
through the opening in the
base for a smooth even
placement on the surface.
x4
D
Acrylic
Enclosure
C
x1
x4
E
L
x2
Security
Star Key
K
M5 Allen
Key
x1
x1
1.Assembling base to body :
CONTENTS :
INSTALLATION:

3. (Optional) Fasten to create a fixed setup: 4. (Optional) Mounting to surface top :
3A - Using provided tool (K), rotate clockwise
at the shown location on kiosk body to create
a locked fixed setup. Rotate until securely
tightened.
K
4A - Using a screwdriver (not included) rotate in screws (I) with anchors (J)
until securely bolted into surface top.
**Screwdriver for illustration
purposes and not included
I
J
6.Setting up device and enclosure :
6A. Align the security star keys x2 (L) and
insert it one in the front screw (D) and one in
the Back screw (E) as shown.
6B. While holding the back security star
key (L) tight in place. Turn the front
security star key (L) counter clock-wise
until all 4 Screws (D) are unscrewed.
6E. While holding the back security star key
(L) tight in place. Turn the front security star
key (L) counter clock-wise until all 4 Screws
(D) are securely fastened.
L
D
6C. Separate front part of enclosure
(C) as shown.
6D. Using one of the compatible listed tablets, insert into the foam adapters
for a secure and tight fit. Insert tablet in back part of enclosure (A) as shown.
Watch out orientation of tablet.
C
A
D
L
D
L
A
F
H
x4
M5 x 12
M5 Nut
5A - Align enclosure VESA holes to the kiosk body VESA plate holes. Using provided tool (K), rotate in screws (F) from above
while holding hex nut (H) from behind with your hands. Rotate until securely tightened.
K
5.Attaching enclosure to stand :
**Tablet for
illustration
purposes and not
included
**Tablet for
illustration
purposes and not
included