CTA PAD-CFWM User manual

Custom Flex Wall Mount
PAD-CFWM
INSTRUCTION - MANUAL
888-733-4448
CONTENTS:
**Drill for illustration
only and not included
Select the appropiate foam pad (D) according to the thickness of
your tablet (or tablet in its case), then press adhesive side into
center of the tablet holder.
Use the table above to
determine the appropiate
foam pad (D) to use with
your tablet.
Note: sizes refer to total
tablet size with or without
a case
Tablet Thickness:
Foam Pad
Thickness:
1mm 0.67-1.06in / 17-27mm
0.51- 0.91in / 13-23mm
0.31- 0.71in / 8-18mm
5mm
10mm
D
B
C
A
1mm
5mm
10mm
G
x1
A
x1
D
x1
INSTRUCTIONS:
1. Attaching Foam Pad to Tablet Holder 2. Installing the Custom Flex Wall
Mount to the Wall
M5 Nut
E
x4
F
M5x12
x4
2a. Drill the holes in
the wall to these
specifications:
diameter: 6.5~7mm
depth: 40~45mm
2b. Knock the
expansion bolts
(C) completely
into the wall.
2c. Fix it with the
screws (B) to the
wall.
B
x4
C
x4
4.8x40mm

888-733-4448
3. Inserting Tablet to Holder
Adjusting Flex Arm Adjusting Tablet Holder
3a. Press quick release button on side of tablet
holder (A) to release the adjustable end.
3b. Insert tablet corner against the spring arm. Push adjustable arm down
against opposite corner (A). Be sure it is as snug as possible. Be sure to not
place on the corner where camera would be on tablet or else it will block.
**Tablet for illustration
only and not included
A
Twist the screw knob of the
arms counter-clockwise to
release the connection.
Adjust the arms to your
preferred position and then
tighten the screw knob
clockwise.
Tablet holder rotates 360°
for custom viewing angles.
**WARNING - DO NOT
attempt to adjust, tilt, or
rotate any ball socket joints
while it is fully tightened.
Any such action will result in
possible damage and loss
of integrity of product
functioning at full capacity.
Manufacturer will not be
responsible for any such
actions by any person.