CTA PAD-HSKSB User manual

Hyperflex Security Kiosk Stand for Tablets
PAD-HSKSB / PAD-HSKSW
INSTALLATION - MANUAL
INSTALLATION:
1. Assembling Base
3. Attaching and Setting up Enclosure
2. Cable Managing
1A. Align holes at the base (B)
with the holes on the base of
the body (A). Screw in bolts (E)
with the provided allen key tool
(J) as shown.
2A. Identify the hole at the bottom of the
base (B) through where cable routing
should go. Then, fish the cable.
2B. Fish the cord through the base and out of the top
to properly tuck away cord as shown above.
CONTENTS:
I
x3
Foam Adapter & Sheet Bundle
K
x1
J
x1
M5 Allen Key
A
x1
B
x1
E
x4
M5 x 8
D
x2
F
x4
M5 x 12
G
x4
M5 Hex Nut
H
x3
C
x1
E
AA
B
B
A
G
C
F
J
3A. Screw in the (4) screws (H) from behind through the enclosure and VESA,
while holding the hex nuts (I) from the front using the allen key tool (J) until
securely tightened.
3B. Once the enclosure is attached, fish the cable
through its rear holes to charge the device.
**Cables shown for illustration
and NOT INCLUDED.
**Cables shown for illustration
and NOT INCLUDED.
3C. Make sure to pop out and off the opening
covers in order to use enclosure at full capacity
and have access to key ports and openings.

Setting Up Device & Enclosure
**Tablet shown for illustration
and NOT INCLUDED.
Insert the appropriate foam piece (K)
that is compatible with your tablet.
Insert tablet as shown. Plug in power
cable to tablet and cable route
through the back.
Place the appropriate provided tablet
cover (K) to match your tablet.
Close the enclosure and lock it
with the included set of keys (D).
K
KD
Optional
Locking Base Rotation
Optional
Mounting into Surface
Turn clockwise to prevent body rotation
using the provided allen key tool (J).
Insert the anchors (H) and then drill in the nails
(I) to the mounting surface as shown above.
B
I
H
J