Cudy POE150 User manual

Quick Installation Guide
Model: POE150/POE200
For support and warranty, please visit: http://www.cudy.com/.
Specifications are subject to change without notice. Cudy is a
registered trademark of Shenzhen Cudy Technologies Co., Ltd.
Other brands and product names are trademarks or registered
trademarks of their respective holders.Copyright©2020 Shenzhen
Cudy Technology Co., Ltd. All rights reserved.
EU declaration of conformity
Cudy hereby declares that the device is in compliance with the
essential requirements and other relevant provisions of directives
2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.The
original EU declaration of conformity may be found at
http://www.cudy.com/
810600073
CE Mark Warning
This is a class B product. In a domestic environment, this product
may cause radio interference, in which case the user may be
required to take adequate measures.
Indicators
System Indicator: AC Power
User Indicator: Channel Power
Connectors
Protection
Shielded RJ-45, EIA 568A and 568B
Over voltage protection
Anti-interference protection
Operating Temperature: 0 to 40℃
Operating Humidity:Maximum 85%
Storage Temperature:-40 to 60℃
Environmental
Conditions
Over current protection
Over load protection
Model
Output Voltage
PoE Power
Pin Polarity
POE150/POE200
Standard
1/2 (-), 3/6 (+)
802.3af/at
Data Rates 10/100/1000Mbps
Input Power
Requirements
Dimensions 121mm x 50mm x 36mm
54VDC
30W max
AC Input Voltage: 100 to 240 VAC
AC Input Current: 0.5A 100-240 VAC
AC Frequency: 50 to 60 Hz
Specifications
4

Power Socket
Ethernet Device
(switch, router, etc.)
1 2 3 4 5 Wireless AP Smart VoIP
IP Camera
PoE Injector
Powered Device (PD)
DATA
IN
P+DATA
OUT
Hardware Connection
1
P+DATA
OUT
DATA
IN
Data/PoE
DATA
IN
P+DATA
OUT
AC Socket
Physical Appearance
2
Data/PoE
Green
Red
PoE injector got 100-240V power input
The terminal equipment connected to
P+DATA port is powered
AC Socket
DATA
IN
P+DATA
OUT
Connect with AC cable
Connect to the Ethernet device with cable to
transmit data.
Connect to the PD device with UTP cable to
supply power.
LED and Interface Explanation
3