Current SILENT TRAC User manual

Zigbee Setup with the Bridge (no App)

1A. Power Bridge
•Find an outlet location
•Insert the micro-usb end of the
included power cable into the
power port on the bridge
•Plug the other end of the cable
into an outet
•Make sure the bridge is installed
or placed 2ft above the ground

1B. Power Bridge
•The LEDs on the bottom of the
bridge will be solid red and green
during startup
•The LEDs will then turn solid red

2. Put bridge in pairing mode
•Push a tack or paperclip into the
hole in the back of the bridge
•Press and hold the recessed
button for 5 seconds or until the
LED begins to flash blue
•Release the button

3A. Add Silent Trac to network
•You are in pairing mode while the
LED is flashing blue. Pairing mode
will time out in 5 minutes. When
the LED turns red, pairing mode has
ended.
•On each Silent Trac you want to pair
to the bridge, pull the pendant
down once to start the curtain, wait
one second, then pull down once to
stop the curtain.
•The green LED will flash, and the
drapery will jog to confirm pairing.

3B. Add remote to network
•Be sure you are still in pairing mode. If
needed, restart pairing mode by
pressing and holding the back button
on the bridge until the LEDs flash blue.
•While in pairing mode, pull the “pull”
tab from the bottom of the remote, or
press and release a button. The LEDs
on the front of the remote will scroll to
show it searching for a network.
•When the LEDs flash, the network has
been found and the remote is
connected.
•If the remote does not find a network,
the LEDs will turn off after 10 seconds.

4A. Pair remote to Silent Trac
•Put the Silent Trac into pairing
mode.
•Pull down and release the pendant
once to start the curtain, wait one
second, then pull down and
release the pendant again to stop
the curtain.

4A. Pair remote to Silent Trac
•Pair remote to Silent Trac
•Select the channel by pressing and
releasing the channel button until
the corresponding LED lights up.
•Use a tack or pen to press and
release the button in the hole on
the back of the remote. The LEDs
on the front of the remote will
scroll.
•Press and release the top left
button on the remote. The curtain
will jog to confirm it has been
paired.