CyberData 011446 Manual

Quick Reference 931429C © 2021, CyberData Corporation, ALL RIGHTS RESERVED© 2021, CyberData Corporation, ALL RIGHTS RESERVED 931429C Quick Reference
Getting Started
• Download the Multicast VoIP Microphone Operations Guide PDF file, from the product page at:
https://www.cyberdata.net/products/011446
• Create a plan for the locations of your Multicast VoIP Microphones.
• WARNING: This product should be installed by a licensed electrician according to all local electrical and building codes.
• WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
• WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant.
•WARNING: This enclosure is not rated for any AC voltages!
Parts
Contacting CyberData
Parameter Factory Default Setting
IP Addressing DHCP
IP Addressa10.10.10.10
Web Access Username admin
Web Access Password admin
Subnet Maska255.0.0.0
Default Gatewaya10.0.0.1
a. Default if there is not a DHCP server present.
(1) Multicast VoIP Microphone
(4) #6 x 1.25 inches
Sheet Metal Screw (4) #6 Ribbed Plastic
Anchor
(1) Mounting Kit
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: 831-373-2601 ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: [phone]
Fax: [phone]
http://www.cyberdata.net/
The IP Endpoint Company
Installation Quick Reference
Multicast VoIP Microphone
SIP Compliant
011446
Desktop Mounting
Mounting Screw
Base Plate
Plastic Ribbed Anchor

© 2021, CyberData Corporation, ALL RIGHTS RESERVED 931429C Quick Reference Quick Reference 931429C © 2021, CyberData Corporation, ALL RIGHTS RESERVED
RTFM Button
Connecting the Network Cable
RTFM
When the device is operational and linked to a
network, you can use the Reset Test Function
Management (RTFM) button to restore the
device to the factory default settings.
To restore the device to factory default settings:
• Press and hold the RTFM button for more
than five seconds, and then release the RTFM
button.
Cable Exit
J1
Mounting Screw
(4 Pieces)
Cable Exit
Network Cable
to J1
Base Plate
Dimensions
Paging to Multicast Enabled Endpoints
4.724 [120.00] 7.087 [180.00]
2.874 [73.00]