Installation Instructions:
•
To attach the WAL you must first remove the front bezel from
the camera by unscrewing the four small screws using a
cross-point screwdriver. The camera bezel screws can be
stored in the threaded holes in the WAL back cover or in the
threaded holes in the back side of the WAL.
•
Attach the WAL to camera with the word “Cyclopital3D” on
the top using the four new thumb-screws provided. Do not
over-tighten the screws- finger tightening is sufficient and the
use of tools is not necessary.
Tips for use:
•
Full zoom through capability. With the WAL attached the
zoom range of the camera becomes 21.5mm to 157mm. The
lens can be used at any zoom setting.
Warranty
Your adapter comes with a Limited Warranty against defects in workmanship and
materials for 30 days from the date of purchase. The limited warranty does not apply if the
product has been damaged by accident, mishandling, misuse, abuse, or alteration.
Care and Maintenance:
•
If you drop the Wide-angle Lens it will break. Please treat it
with the same care you would give to any expensive camera
lens. If the unit sustains impact damage it may be possible to
repair it using super glue (cyanoacrylate), which bonds well to
the composite material used in its construction.
•
In the unusual case that the internal glass of the lenses gets
dirty, the unit can be disassembled and cleaned by someone
skilled in working with delicate optical devices. If you are in
doubt of your capabilities, Cyclopital3D can clean the unit for
a small fee.
All rights reserved Cyclopital3D Inc. 2012
