D-Link DSL-2750E Setup guide

Step 1: Connect device
1.1 Connect telephone line from wall outlet to DSL-2750E directly or
1.2 If you wish to use internet and your telephone at the same time, please use the splitter that
comes with the packaging box.
The splitter has three ports:
LINE: Connect to a wall phone jack (RJ-11 jack)
Modem: Connect to the Line interface of the router
PHONE: Connect to a telephone set
1.3 Use LAN Cable (CAT5E: RJ45) to connect your computer to any LAN port of DSL-2750E.
Step 2: Login to Router
2.1 Open Web Browser (Internet Explorer, Firefox, Google Chrome) and enter
http://192.168.1.1 on the Address Bar.
2.2 On the login page, please enter username and password and click ‘Login’.
Default Username and Password:
Username: admin
Password: admin

Step 3: On the device Setup page, please click on ‘Setup Wizard’ to run the step-by-step
configuration wizard.
3.1 Click ‘Next’ to continue.
3.2 The Time Configuration option allows you to configure, update, and maintain the correct
time on the internal system clock. From this section, you can enable or disable Daylight Saving
and set the time zone that you are in and set the NTP (Network Time Protocol) Server. Click
"Next" to proceed to next step.
3.3 PPPoE Configuration:
3.3.1 Please select Country: Malaysia
3.3.2 ISP: Please select your Internet Service Provider (such as: Streamyx-PPPOE)
After you have selected your Internet Service Provider, the wizard will fill up VPI and VCI
setting automatically.
3.3.3 Protocol: Select PPPoE
Please insert your PPPoE username and password (these parameter comes from your Internet
Service Provider).

Enter password twice (Password and Confirm Password)
Click Next.
3.4 Wireless (WIFI) Setup:
3.4.1 Check the ‘Enable Your Wireless Network’ box.
3.4.2 Enter your preferred wireless network name (SSID).
3.4.3 Enter your wireless encryption key. If you do not want to setup Wireless Security, please
Select ‘None’.
Example of WPA key configuration: Select WPA2 , WPA2 Pre-Shared Key is 12345678
Click Next.

Step 4: Change administrator password:
Default Username and Password:
Username: admin
Password: admin
4.1 If you do not wish to change the administrator password, please click ‘Skip’
4.2 Please follow steps below if you wish to change password,
Current Password: Insert current Password (Default Password is admin)
New Password: Insert new Password
Confirm Password: Insert new Password again
Click Next.
Step 5: This page shows a summary of setup that you have just completed. Click Apply.
Step 6: The device will reboot. You may start using the device after rebooted successfully.