For example, to change the shutter setting from off to auto:
1. Press MENU. WHITE BALANCE will be flashing.
2. Press DOWN. SHUTTER will be flashing.
3. Press RIGHT. OFF will be flashing.
4. Press UP or DOWN to scroll through the available
settings, when AUTO appears, stop.
5. Press MENU to store AUTO and turn off display, or
press LEFT then UP or DOWN to edit other menu
items in a similar matter.
NOTE: When editing MANUAL WHITE BALANCE and
CAMERA TITLE,an additional RIGHT press is needed to
activate the adjustment cursor, then UP/DOWN to change
values and LEFT/RIGHT to change characters as necessary.
White Balance
One Push: By pressing the ONE PUSH (AWB)on the
remote, the camera automatically white balances to the
present scene, then stores setting until ONE PUSH is
pressed again or camera power is turned off. When
camera power is turned back on a ONE PUSH (AWB)
cycle is performed. Pressing the ONE PUSH button
automatically changes the White Balance menu setting
from the previous setting to the ONE PUSH setting.
There must be adequate white area in the scene and
illumination to perform a white balance or the camera
will wait before completing the white balance. The
typical method of white balancing in this mode is to
set the illumination level, place a white object in the
scene (if there is not enough white in scene), then
press ONE PUSH. ONE PUSH (AWB)should be
readjusted when light intensity is changed.
