Dali PHANTOM CI AMP-2500 DSP User manual

DALI A/S www.dali-speakers.comDALI PHANTOM CI AMP-2500 DSP IWI-FI / LAN SETUP
DALI PHANTOM CI
AMP-2500 DSP
WI-FI / LAN SETUP
Before you begin:
DALI recommends
starting with Wi-Fi
Hotspot setup, before
configuring your Wi-Fi
or LAN connection.
Wi-Fi Hotspot Mode Setup
The default LAN address is: 192.168.4.1
Ethernet/LAN Setup
When an Ethernet cable is connected, a new IP address is assigned
by the router. To discover the new IP address, and gain access to the
dashboard, an IP address scan of the LAN network may be required.
(The AMP-2500 has DHCP set to ON by default.)
By: Thomas Holm. Senior Product Specialist, DALI Loudspeakers
Use a mobile, laptop or desktop
device to search for a new
PHANTOM Wi-Fi network
Connect to “PHANTOM AMP-
2500 DSP (product serial
number)” using the password
“password”. (The amplifier serial
number can be found on its rear
panel).
First step: Wi-Fi Hotspot Setup:

DALI A/S www.dali-speakers.comDALI PHANTOM CI AMP-2500 DSP IWI-FI / LAN SETUP
Open a smart phone, tablet
or computer web browser
and enter the IP address:
192.168.4.1
The DALI PHANTOM CI
AMP CONFIGURATOR web
interface will open to enable
amplifier configuration as
required.
To connect the AMP-2500 to your
own or client’s Wi-Fi network, go
to ‘Seings’ -> ‘WIFI’ and press the
‘Client’ tab.
This will enable you to pe in
your SSID and password for your
client’s Wi-Fi network.
When an Ethernet cable is
connected, a new IP address
is assigned by the router.
To discover the new IP
address, and gain access
to the dashboard, an IP
address scan of the LAN
network may be required.
(The AMP-2500 has DHCP
set to ON by default.)
WI-FI SETUP CONTINUED:
Navigate to the AMP CONFIGURATOR Dashboard:
Connect the AMP-2500 to your own Wi-Fi:
Ethernet connection (LAN):
If you are already connected to the AMP-2500 via Wi-Fi hotspot mode or Wi-Fi, the LAN IP address can be found in
the Status window of the Dashboard, aer you connect the LAN cable.
If you want to configure a fixed LAN IP address this can be done under Seings -> LAN.