DANDELION DBUNT2 User manual

SKU: DBUNT2SKU: DBUNT2
WOOD NESTING TABLESWOOD NESTING TABLES
USER GUIDEUSER GUIDE
RESPONSIBLY CREATING BETTER PRODUCTS FOR A BETTER WORLD

w
Table of Contents
USER GUIDEUSER GUIDE
2
Parts DiagramParts Diagram
AssemblyAssembly
InstructionsInstructions
Contact UsContact Us

PARTS DIAGRAMPARTS DIAGRAM
3
C. Large Tabletop x1
A. Small Tabletop x1
D. 32” leg x4
B. 24” Leg x4
NOTE:
1. Two people are required.
2. A rubber mallet is needed to finish the assembly.
3. It’s recommended to assemble the unit on a smooth floor covered with soft
cloth or a cardboard to avoid damage to your tabletops.
WARNING: DO NOT SIT, CLIMB OR LEAN ON THE TABLETOP!

ASSEMBLYASSEMBLY
INSTRUCTIONSINSTRUCTIONS
4
1. Insert one 24” Leg (B) into a pre-drilled hole at one corner of the
Small Tabletop (A). Twist the tenon in first, then use a rubber mallet
(not included) to tap the leg until it’s fully inserted.
2. Repeat Step 1 to assemble the remaining 24” legs onto the small
tabletop. Carefully turn the table over to its standing position.

ASSEMBLYASSEMBLY
INSTRUCTIONSINSTRUCTIONS
5
3. Place the Large Tabletop (C) on the protected floor and make sure the
side with 4 corner pieces are facing up. Assemble one 32” Leg (D) at a corner
the same way as the small table and use your rubber mallet as needed.
4. Assemble remaining 32” legs to the large tabletop and make sure all
legs are fully inserted and secured. Carefully turn the large table over to
its standing position.

ASSEMBLYASSEMBLY
INSTRUCTIONSINSTRUCTIONS
6
5. Then assembly is finished. Enjoy your nesting tables.

7
CONTACT USCONTACT US
THANK YOU FOR SPREADINGTHANK YOU FOR SPREADING
THE SEEDS OF SUSTAINABILITYTHE SEEDS OF SUSTAINABILITY
AND HELPING TO PROTECTAND HELPING TO PROTECT
OUR PLANETOUR PLANET
H   G   H   G   
 D  : D  :
888-257-6639888-257-6639
DANDELION