212-0100 3 10 MAR 2017
General Warning
1. The use of emergency warning devices does not ensure the safety of the operator. The operator is
responsible to ensure safe operation of the vehicle regardless of whether the warning device is in
operation or not
2. The effectiveness of this or any warning device is highly dependent on proper installation and
maintenance. Read the manufactures instructions before installing and follow all recommenda-
tions.
3. When in use the operator must ensure that the warning signal is visible and not obstructed by vehi-
cle components (i.e. open trunk lid), people or other obstructions
4. This device is intended for use by authorized personnel only The user is responsibility to ensure
that all local, state/provincial and federal laws are being complied with. D&R assumes no liability
for any loss resulting from the use of this device.
5. The device must be installed so as not to reduce the output performance of vehicle systems
6. Placement of control switches must be so as to provide convenient reach for the operator without
loosing eye contact with the road.
7. Emergency warning devices require high electrical voltages and/or currents. Properly connect and
ground all circuits. Shorting or improper grounding of this device may caused personal injuring,
vehicle damage or both
8. Use ear protection while installing siren system or speaker, activation of siren may damage un-
protected ears.
9. All operators should be properly trained in the operation of this device to ensure both their and
public safety
Installation and Mounting
1. Any device used inside a vehicle, may cause severe personal injury if not properly mounted and
secured. Objects used in the vehicle may become airborne during a collision or other sudden chang-
es in vehicle speed or direction, such as braking, acceleration or turns.
2. Be sure to mount unit through the steel of the vehicle. Avoid mounting through plastic or other
non-structural materials.
3. POINT OF INSTALLATION MUST NOT INTERFERE WITH DEPLOYMENT OF VEHI-
CLE AIR BAGS.
4. DO NOT mount the system in a location that will obstruct the driver’s view. Ease of operation
should be the PRIME consideration in mounting the ARROWBOARD electronic system.
5. DO NOT mount the CONTROLLER in a location that will interfere with the airbags. (For safe
equipment mounting zones in your vehicle, consult your vehicle manufacturer’s recommended guide-
lines).
6. D&R Electronics recommends this or any of our products be installed by qualified profes-
sionals.
Warning
