Danelectro FAB Distortion D-1 User manual

FAB
Distortion
INSTRUCTIONS
© EC 2005 Printed in China
D-1
EEC Agent:
John Hornby Skewes & Co., Ltd.
Sa em House, Parkinson Approach,
Garforth, Leeds LS25 2HR UK
This product complies with FCC Part 15 rules.
Operation of this product is permitted in USA
provided this product does not cause harmful
interference and provided this product accepts
interference from other devices, even if that
interference is detrimental to performance of
this product.

TONE:
Adjusts the EQ
DI TORTION:
Adjusts the amount
of Distortion
LEVEL:
Adjusts the
output level
BATTERY: Uses one -006P 9-Volt Battery. Danelectro “Vintage Power
ource” batteries are recommended.
BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro “Zero Hum”
Battery Eliminators are recommended.
FAB
Distortion
TO BEGIN:
• Connect instrument cable to the IN jack.
Connect amplifier cable to the OUT Jack. If using
an AC Adapter, connect to DC-9V jack. Or use
9Volt battery.
• LED light will be on when foot switch is
activated.
CONTROL FUNCTION :
LEVEL: This control sets the level of the output to
the amplifier.
TONE: Rotate this control to adjust the EQ.
DI TORTION: Use this control to set the amount of
Distortion.
caution:
This is a high gain device. tart with the LEVEL
control at 25% and then advance as needed.
D-1 Instructions
INPUT 9VDC OUTPUT

TONE:
Adjusts the EQ
DI TORTION:
Adjusts the amount
of Distortion
LEVEL:
Adjusts the
output level
BATTERY: Uses one -006P 9-Volt Battery. Danelectro “Vintage Power
ource” batteries are recommended.
BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro “Zero Hum”
Battery Eliminators are recommended.
FAB
Distortion
TO BEGIN:
• Connect instrument cable to the IN jack.
Connect amplifier cable to the OUT Jack. If using
an AC Adapter, connect to DC-9V jack. Or use
9Volt battery.
• LED light will be on when foot switch is
activated.
CONTROL FUNCTION :
LEVEL: This control sets the level of the output to
the amplifier.
TONE: Rotate this control to adjust the EQ.
DI TORTION: Use this control to set the amount of
Distortion.
caution:
This is a high gain device. tart with the LEVEL
control at 25% and then advance as needed.
D-1 Instructions
INPUT 9VDC OUTPUT

FAB
Distortion
INSTRUCTIONS
© EC 2005 Printed in China
D-1
EEC Agent:
John Hornby Skewes & Co., Ltd.
Sa em House, Parkinson Approach,
Garforth, Leeds LS25 2HR UK
This product complies with FCC Part 15 rules.
Operation of this product is permitted in USA
provided this product does not cause harmful
interference and provided this product accepts
interference from other devices, even if that
interference is detrimental to performance of
this product.