Danfuss 132B0303 User manual

The instructions provide information about the replacement of
the cradle in the J6 enclosure type of the VLT
®
Automa-
tionDrive FC 360.
Only Danfoss-authorised, qualified personnel is allowed to
repair this equipment. The personnel must be familiar with the
instructions and safety measures described in the
VLT
®
AutomationDrive FC 360 Service Manual.
1.1.1 Items Supplied
Items supplied depend on ordered code number and
enclosure type of the frequency converter.
Code number Items supplied
132B0303
•
Cradle for power card & busbar, enclosure type
J6
1.1.2 Tools Required
•
Screwdrivers:
-Flat-edged
-T10
-T20
-T25
-T30
•
N8 socket wrench
•
N10 socket wrench
•
N5 Allen key
1.1.3 Safety Instructions
WARNING
DISCHARGE TIME
The frequency converter contains DC-link capacitors, which
can remain charged even when the frequency converter is
not powered. Failure to wait the specified time after power
has been removed before performing service or repair work,
could result in death or serious injury.
1. Stop the motor.
2. Disconnect AC mains, permanent magnet type
motors, and remote DC-link power supplies,
including battery back-ups, UPS, and DC-link
connections to other frequency converters.
3. Wait for the capacitors to discharge fully, before
performing any service or repair work. The duration
of waiting time is specified in Table 1.1.
Voltage [V]
Minimum waiting time (minutes)
415
380-480 0.37-7.5 kW 11-75 kW
High voltage may be present even when the warning LEDs are off!
Table 1.1 Discharge Time
Installation Instructions
Cradle for Power Card & Busbar
VLT®AutomationDrive FC 360
Danfoss A/S © Rev. 2014-02-12 All rights reserved. MI06S102

1.1.4 Installation
Replacing the Cradle for Enclosure Type J6
1. Follow the instructions in VLT
®
AutomationDrive FC
360 Service Manual to remove the power card.
2. Detach the power card from the cradle.
3. Replace the cradle.
4. Reinstall other unmounted components in reverse
order.
*MI06S102*
MI06S102132R0225 Rev. 2014-02-12