Dante DFC9200 Series User manual

DFC9200 19” Subrack Frame
Ethernet Cards
Installation and Operations Manual
Model Number: DFC9200
Description: 19” Subrack ith 1 Po er Supply

Table of Contents DFC9200 Subrack Page
About This Manual DFC9200 Subrack 3
Features 4
Typical Application 5
Attention 6
Instructions 6
Po er Input Panel 7
Rear Subrack Panel 7
LED Status Indicators for TRX 7
ELECTRICAL SPECIFICATIONS 8
GENERAL PARAMETERS 8
PHYSICAL SPECIFICATIONS 8
INSTALLATION 8

About this manual DFC9200 Series
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
The explanation given in this manual can be applied to the
follo ing model unless noted other ise.
DFC9200-1 19” x 2U Subrack, 16 Slots and 1 Po er Supply
arning
Do not open the enclosure. No spare parts are present
inside the unit. Refer servicing to equipment dealer or our
company.

Features
 19”L x 3.5”H (2U) Subrack Frame and PSU
 Highest Density in Surveillance Industry
 16 Single Card Slots and 1 Po er Supply
 Cards & PSU Po er-on LED Status Indicators
 Hot s appable Card Units
 100-240VAC, Auto Ranging PSU
 Regulatory Compliance ith UL, CE and FCC

The application

ATTENTION
 Do not exceed the range of the adaptor between
100-240VAC
 For Indoor environment, operating temperature and
humidity are controlled ithin the orking parameter or
else may cause damage to the units.
 Use the protective covers for optical transmitters hen
not connected ith patch cords – avoids dust.
INSTRUCTIONS
Remote TRX
The transmitter uses the standalone module design and is
easy to install in NEMA equipment enclosure. Additionally,
power, data, channel signal are easily inspected from the
indicators on the front and rear panels.
Rack mount TRX
Card is a standard rackmount TRX for installation via
upper and lower card guides of 19” Subrack.

The Power Input Rear Panel
Power input panel features input socket, on/off switch and
LED indicator light：
LED Color Function
FunctionFunction
Function
FX 1000 Green Lit when 1000Base-FX operation.
FX
Link/ACT
Green Lit when fiber cable connection
with remote device is good. Blinks
when any FX traffic is present.
Power Green Lit when +5V Power is available.
FDX Green Lit when Full Duplex Mode is
enabled.
TX 1000 Green Lit when 1000Base-TX operation.
TX
Link/ACT
Green Lit when the TP cable connection
with remote device is good. Blinks
when TX traffic is present.

ELECTRICAL SPECIFICATIONS
Input Voltage 100/240VAC, 50/60Hz
Po er Consumption 80
Output Voltage 5V
Ripple ≤50mV
Noise ≤50mV
GENERAL PARAMETERS
Po er on LEDs Cards and PSU
PHYSICAL SPECIFICATIONS
Operating Temperature -10°C ~ +50°C
Relative Humidity 5% - 95% non-condensing
External Dimensions 19” (485mm) L
9.65” (245mm) D
3.5” (90mm) H
Weight of Equipment 8 lbs (3.5Kg)
INSTALLATION
 Open the package and inspect the unit, no sounds of
loose items should be heard from inside.
 Po er Connection
Plug the po er cord into the po er supply source. Turn the
po er ON/OFF s itch to the 1 (ON) position. Po er LEDs on
cards, illuminate to indicate that receiver operates normally.