Darkglass Electronics Alpha Omega Super Intelligent Footswitch User manual

USER MANUAL

Alpha·Omega
Super Intelligent
Footswitch
The perfect addition
Alpha·Omega Super Intelligent Footswitch has three
programmable footswitches for assigning channels (Clean,
Alpha, Omega, Mod) and compressor state (On or Off). It also
has a separate mute footswitch. The channel footswitch
functions are programmed through Darkglass Suite, and
settings are stored on the Alpha·Omega 900 amplifier.
Warning
The Super Intelligent Footswitch will only work with our
amplifier, the Alpha·Omega 900.
Technical Specifications
Dimensions
Width 220 mm (8.66 in)
Height 45 mm (1.77 in)
Depth 48 mm (1,88 in)
Weight 450 g (0.99 lb)

Controls
A (Default Setting): Clean, compression Off.
B (Default Setting): Clean, compression On.
C (Default Setting): Distortion (Mod), compression On.
Mute: Mutes the amplifier for tuning or other purpose.
Warranty
To activate the warranty, we encourage you to register your
product on: http://mypedal.darkglass.com and enter the serial
number on the back of your pedal.
Please contact us via email [email protected] before
shipping a product to us.
Disclaimer
In the interest of continuous improvement, specifications are
subject to change without notice. If you have any questions,
please don’t hesitate to contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the
requirements as set by EN55013, EN55020, EN60555-2,
EN60555-3, RoHS, WEEE.

EMC / EMI
This equipment has been tested and found to comply with the
limits for a Class B Digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in residential
installations.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. There is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and
receiver.
· Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for
help.

DARKGLASS ELECTRONICS OY.
Elimäenkatu 20A, 2nd floor
00150 Helsinki, Finland
www.darkglass.com