Super Symmetry
115 GeV Compressor
The Universe is the Limit
The Super Symmetry offers all the transparency and precision of a
modern compressor with the twist that its inherent envelope effect is
reminiscent of old school compressors.
Warning
The Super Symmetry has a current draw of 30mA. Only use a
regulated 9V DC adapter with a center-negative plug. Due to
ecological reasons it does not accept batteries. Unregulated power
supplies and/or higher voltages may result in suboptimal noise
performance and even damage your unit, voiding the warranty.
Warranty
To activate the warranty, we encourage you to register your product
on: http://mypedal.darkglass.com and enter the serial number on
the back of your pedal.
shipping a product to us.
Tip
For optimal noise performance it's advisable to set the Input knob as
high as possible while maintaining a clean operation. This will help
minimize the noise floor increase inherent to any kind of compression.
Controls
BLEND: Mix the compressed and clean signals, ideal for fast
compression adjustment (to reduce it you can dial back the blend and
avoid having to readjust your Input and Output levels for unity gain).
INPUT: Adjusts the gain on the compressor. Besides working great
for ensuring clean operation, it also allows for adjusting the
threshold over which the compressor starts reducing gain. Higher
input settings will result in higher levels of compression.
ATTACK: Sets the time until gain reduction begins (higher settings
will translate into faster Attack times).
RELEASE: Sets the time after which the signal goes back to pre
gain-reduction levels. Higher release settings will hold the
compressed signal for shorter time.
COMPRESSION: Sets the amount of compression (Peak Reduction).
OUTPUT: Sets the output volume level of the unit.
Disclaimer
In the interest of continuous improvement, specifications are subject
to change without notice. If you have any questions, please don’t
hesitate to contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the
requirements as set by EN55013, EN55020, EN60555-2, EN60555-3,
RoHS, WEEE.
