Dash FOUR x SIX User manual

FOUR x SIX
WORKSTATION
QUESTIONS/CONCERNS/HELP? EMAIL US
AT: [e-mail]
FOLLOW US ON INSTAGRAM
@DASHMODERN AND USE TAG #DASHLIFE

• MAKE SURE THERE IS AN AREA OF WALL FREE OF LIGHT SWITCHES, OUTLETS AND OTHER OBSTRUCTIONS
THAT COULD PREVENT PROPER INSTALLATION.
• WALL OUTLET HEIGHTS CAN VARY BASED REGIONAL ELECTRICAL CODES AND/OR AGE OF YOUR HOME.
• THE INCLUDED 15” WOOD SPACER SHOULD MAKE SURE THE PANEL MOUNTS ABOVE MOST WALL OUTLETS,
BUT ADDITIONAL HEIGHT MAY BE NECESSARY TO CLEAR THE OUTLET COMPLETELY.
WHAT’S INCLUDED
PLACEMENT CONSIDERATIONS
(1X) FOUR x SIX PANEL
39”W x 55”T
(12X) 2” SCREWS (4X) WALL
ANCHORS
(2X) 1” BLACK
SCREWS
(Depends on Kit)
8”x8” BIRCH
FILL PLATES
(1X) LARGE DESK
34”W x 22”T
(1X) INSTALL SPACER
15”W x 15”T

INSTALLATION
1. LOCATE A GOOD SPOT ON YOUR WALL
(PREFERABLY CLOSE TO AN ELECTRICAL
OUTLET).
4. USE A STUD FINDER TO FIND THE STUDS IN
THE WALL, THEN MARK THE WALL ABOVE THE
PANEL INDICATING WHERE THE STUDS ARE.
7. ONCE THE FIRST SCREW IS IN YOU CAN PLACE
A LEVEL (OR YOUR PHONE IF YOU HAVE A LEVEL
APP) ON THE TOP EDGE OF THE PANEL. CHECK
TO MAKE SURE THE PANEL IS PERFECTLY LEVEL...
ADJUST AS NEEDED.
2. PLACE THE INSTALLATION SPACER ON THE
FLOOR IN AN UPRIGHT POSITION LEANING
AGAINST THE WALL AT THE MIDPOINT OF
WHERE YOUR PANEL WILL GO.
5. IN THE TOP LINE OF HOLES ON THE PANEL,
IDENTIFY A HOLE THAT CORRESPONDS WITH A
STUD.
8. ONCE THE PANEL IS LEVEL, IDENTIFY OTHER
HOLES THAT LINE UP WITH STUDS AND SCREW
IN FASTENERS. MINIMUM OF EIGHT FASTENERS
INTO STUDS RECOMMENDED.
3. PLACE THE MIDDLE LINE OF THE PANEL ON
THE SPACER AND PRESS PANEL FLAT AGAINST
WALL.
6. SCREW IN A FASTENER THROUGH THAT HOLE.
MAKE SURE THE HEAD OF THE FASTENER IS
FLUSH WITH THE WOOD, OR SLIGHTLY SUNKEN.
9. REMOVE SPACER. FOR ADDITIONAL
FASTENING NOT INTO A STUD, FOUR RED WALL
ANCHORS ARE ALSO INCLUDED WITH KIT.
WALL STUDS
MAKE SURE AT LEAST
40” OF UNINTERUPTED
WIDTH AVAILABLE
MIDDLE LINE

D A
S H
FIG. 4
FIG. 5 FIG. 6
WHEN DESK IS PROPERLY SEATED INTO PANEL THERE WILL BE NO VISIBLE GAP ALONG BOTTOM EDGE.
DESK HEIGHT EQUALS APPROXIMATELY 30” IF
USING INCLUDED SPACER.
HOLES IN DESK WILL ALIGN WITH PANEL HOLES.
INSERT SUPPLIED SCREWS (2X).
IF SCREW DOES NOT CONNECT TO THREADED
INSERT ON PANEL, THIS COULD BE DUE TO AN
UNEVEN WALL. PANEL HARDWARE SHOULD BE
ADJUSTED SLIGHTLY TO MAKE SURE PANEL IS AS
FLAT AS POSSIBLE.
(NOTE: DO NOT INSTALL SCREWS IN DESK IF YOU
PLAN TO FREQUENTLY ADJUST DESK HEIGHT.)
✔
✘
SPACER
30”