Data Video RKM-572 User manual

www.datavideo.us
RKM-572 Holder
Instruction Manual
Included Accessories:
Hex Screws (24 pcs)
10-32 x 5/8”
Hex drive
Nylon Washers (24 pcs)
Nylock Nuts (8 pcs)
10-32 thread insert size
Tinnerman Clips (16 pcs)
10-32 thread insert size
Required Tools:
Crescent wrench or 3/8 wrench
1/8 Hex Key (1 pc) (included)

2
Holder Assembly
Step 1: Lay the base flat on a hard surface.
Step 2: Place the side bar vertically on top of the base (outer
placement).
Step 3: Place the washer onto the screw, and insert the screw
through each of the 8 bottom holes. Secure the screws with nylock
nuts.
Step 4: Repeat steps 2 and 3 for the second side bar.
Mounting the Units
Step 5: Slide the Tinnerman clips onto the sidebar over the holes.
Step 6: Starting from the top of the holder, place the TLM-702
monitor on top of the Tinnerman clips.
Step 7: Place the washer onto the screw and insert the screw into
Tinnerman clip to secure the monitor in its place.
Step 8: Place the ITC-100 intercom on top of the Tinnerman clips
right below the monitor.
Step 9: Place the washer onto the screw and insert the screw into
Tinnerman clip to secure the intercom in its place.
Step 10: Place the DN-500 recorder on top of the Tinnerman clips
below the intercom. NOTE: You may have to wiggle the unit a bit to
slide it in the holder.
Step 11: Place the washer onto the screw and insert the screw into
Tinnerman clip to secure the recorder in its place.