DataComm Electronics 70-0078 User manual

08/09/14 Rev. 2
Instruction/ Installation Sheet
DataComm Electronics 4-Gang 110 4x8 Phone Plate &
1x6 Splitter with Tester 70-0078
Telephone Installation
•Locate the central point where all telephonehome runs meet.
•Install either a 4-gang mounting bracket or a 4 gang switch box at the central
point where the telephone wires come together.
•Install the cable from the telephone company demarcation point to the top 110
IDC on the plate.
•Install the remaining twisted pair cables from each location in the house to the
remaining 110 IDC connectors. Match the color-coding of the wires to the colors
on the 110 IDC connectors. To connect phone service, insert the three inch
patch cord into the Telcoport and the Home port. Incoming service can be tested
using the Telco port.
•The wires should be puncheddown, using an industry standard punch-down tool,
to the 110 IDC connectors following the T568A wiring configuration as shown
below.
•Secure the plate to either the mounting bracket or switch box.
•Line1is Blue, Line2is Orange, Line 3 is Greenand Line4is Brown.
White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
Video Installation
•Attachamale F-connector onto the cable TV service or satellite service incoming
cable. Screw the incoming cable with F-connector to the connector marked
input.
•Using F-connectors, terminate all coaxial leads thathave beenpulled through the
four gang in the wall to the remaining connectors on the splitter.
INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com

08/09/14 Rev. 2
Instruction/ Installation Sheet
DataComm Electronics 4-Gang 110 4x8 Phone Plate &
1x6 Splitter with Tester 70-0078
CAUTION
•Never install telephone wiring during lighting storms.
•Never install telephone jacks in wet locationsunless the jack is
specifically designed for wet locations.
•Never touch un-insulated wires or terminals unless the telephone
line has been disconnected at the network interface.
•Use caution when installing or modifying telephone lines.
IMPORTANT INSTRUCTIONS
•Read and understand all instructions.
•Follow all warnings and instructions marked on the product.
•Do not use this product near water, for example near a bath tub,
wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
• SAVE THESE INSTRUCTIONS.
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
ETL LISTED
CONFORMS TO
UL STD 1863
ANSI/UL STD 60950
CERTIFIED TO
CAN/CSA STD C22.2 NO 60950- 1