JMA WPS-DF-K Configuration guide

Install Instructions
JMA Wireless Weather Protection System
For 1/2” Connectors to Antenna or Device
7645 Henry Clay Blvd. | Liverpool, NY 13088 | Tel: [phone] | [email protected] | www.jmawireless.com
Materials
Step #1 Install WPS-4A or WPS-4S and 1/2” Connector
1/2” JMA WIRELESS
CONNECTOR
TQ-114-F18
TORQUE WRENCH
13009-01 Rev. C
WPS-DF-K
(FOR ANTENNA/ DEVICE)
WPS-4A / WPS-4S
(FOR CONNECTORS)
Place the WPS-DF-K onto the
antenna or device female port.
Step #2 Install WPS-DF-K
Properly installed WPS-DF-K.
Ensure that the WPS-DF-K is
properly placed on the antenna
or device port, positioned just
past the threads.
Slide the WPS-4A or WPS-4S
onto the 1/2”cable 6-12 inches
from the end prior to cable
preparation.
Prep and install the 1/2”
cable to install the JMA
Wireless compression
connector. Refer to the 1/2”
annular install instructions.

7645 Henry Clay Blvd. | Liverpool, NY 13088 | Tel: [phone] | [email protected]| www.jmawireless.com
Step #3 Connect and Torque Interface
Install Instructions
JMA Wireless Weather Protection System
For 1/2” Connectors to Antenna or Device
Slide the WPS-4A or WPS-4S
over the 1/2”connection
making sure to overlap the
port seal.
13009-01 Rev. C
Step #4 Install WPS-4A or WPS-4S
Connect the 1/2” connector to
the antenna port or device, and
hand tighten.
Properly installed connector.
Torque the connection to 18
ft-lbs using the TQ-114-F8
torque wrench.
WPS-4A or WPS-4S should
completely cover the rst
set of WPS-DF-K grooves as
shown.
Completed installation of
the jMA Wirelss Weather
Protection System.