Datalogic Magellan 1100i User manual

© 2009-2010 Datalogic Scanning, Inc. R44-3042 (Rev. A) 3/10
Magellan
TM
1100i
Fixed Mounting Plate Instructions
Securing the Fixed Mounting Plate
This sturdy plate can be used to mount the scanner in a number of positions;
either for new installations or to add to an existing system.
New Installation
1. Determine the mounting location. The plate allows flexible, yet sturdy
mounting to a countertop, table, wall, or even under a counter. While
deciding on the best position, you might want to keep in mind the best
way to route the scanner cable (you may need to drill a hole for it).
2. Using two of the screws provided in the kit, securely fasten them down
through the plate in the position desired.
Countertop Wall
Under Counter

© 2009-2010 Datalogic Scanning, Inc. R44-3042 (Rev. A) 3/10
Existing Installation
1. For your convenience, the Fixed Mounting Plate has been designed to
mount to the same hole patterns that have already been drilled for a scan-
ner being replaced. Just push the new screws up through the existing holes
to secure the mounting plate in place of the old unit. If the screw pattern
doesn’t match, attach using the New Installation instructions.
Latching/Unlatching the Scanner
1. To latch, engage the front latches as shown in the “Latching” illustration,
then rotate the rear of the scanner down onto the stand to secure the scan-
ner in the rear latch.
2. Unlatching: Grasp the scanner as shown and rotate the rear up and away
from the stand to disengage the rear latch, then the opposite end away
from the front latches.
Rear
Latch
Scanner
Rear
Latch
Latching Unlatching
Front
Latches