Datalogic Formula F732 WIZARD User manual

F734/F732 BATTERY INSTALLATION
To install the batteries correctly, proceed as follows:
1- Turn over the terminal
and remove the two
battery cover screws.
2- Insert the battery pack
making sure the
batteries are placed in
the direction indicated
in the figure.
CAUTION
Before inserting the battery pack into the
terminal, ensure the battery polarity matches
with the one indicated within the case.
852000021 (Rev. B)
F734/F732 BATTERY INSTALLATION
To install the batteries correctly, proceed as follows:
1- Turn over the terminal
and remove the two
battery cover screws.
2- Insert the battery pack
making sure the
batteries are placed in
the direction indicated
in the figure.
CAUTION
Before inserting the battery pack into the
terminal, ensure the battery polarity matches
with the one indicated within the case.
852000021 (Rev. B)
F734/F732 BATTERY INSTALLATION
To install the batteries correctly, proceed as follows:
1- Turn over the terminal
and remove the two
battery cover screws.
2- Insert the battery pack
making sure the
batteries are placed in
the direction indicated
in the figure.
CAUTION
Before inserting the battery pack into the
terminal, ensure the battery polarity matches
with the one indicated within the case.
852000021 (Rev. B)
- +
+
-
-+
+
-
- +
+
-

Figure A Figure B
CAUTION
When inserting the battery pack, first slide it
towards the springs compressing them until the
contacts at the other end are cleared (see
Figure A). Then, push downwards to insert the
pack (see Figure B). Be very careful not to
damage the contacts when pushing downwards.
3- Close the battery cover and tighten the screws.
WARNING
Do not incinerate, disassemble, short
terminals or expose to high temperature.
Risk of fire, explosion. Use specified charger
only. Risk of explosion if the battery is
replaced by an incorrect type. Dispose of the
batteries as required by the relevant laws in
force.
Figure A Figure B
CAUTION
When inserting the battery pack, first slide it
towards the springs compressing them until the
contacts at the other end are cleared (see
Figure A). Then, push downwards to insert the
pack (see Figure B). Be very careful not to
damage the contacts when pushing downwards.
3- Close the battery cover and tighten the screws.
WARNING
Do not incinerate, disassemble, short
terminals or expose to high temperature.
Risk of fire, explosion. Use specified charger
only. Risk of explosion if the battery is
replaced by an incorrect type. Dispose of the
batteries as required by the relevant laws in
force.
Figure A Figure B
CAUTION
When inserting the battery pack, first slide it
towards the springs compressing them until the
contacts at the other end are cleared (see
Figure A). Then, push downwards to insert the
pack (see Figure B). Be very careful not to
damage the contacts when pushing downwards.
3- Close the battery cover and tighten the screws.
WARNING
Do not incinerate, disassemble, short
terminals or expose to high temperature.
Risk of fire, explosion. Use specified charger
only. Risk of explosion if the battery is
replaced by an incorrect type. Dispose of the
batteries as required by the relevant laws in
force.
CONTACTS CONTACTS
CONTACTS