DataRemote CDS-9010 User manual

Revision No. 005 August 2020
If your new device did not come with a SIM card
pre-installed, please follow the SIM install directions:
Inside the right battery port, the SIM card slots are located
on the left bottom corner of your device. Insert the SIM
card inside the slot marked “SIM 1”. Make sure is inserted
all the way into the slot. You will feel a spring lock the SIM
card into place.
STEP 1
IMPORTANT:
QUICK START GUIDE
CDS-9010
Before starting to configure the router, you have to
connect your devices correctly, follow these "step by
step" directions as shown below. If you have any
questions regarding installation, please contact your
Support Team
For more information on
how to configure your DATAREMOTE
CDS-9010 Device, please visit
Support.DataRemote.com
Then Insert the batteries in to the battery ports on the
sides of your CDS-9010 device, making sure they will click
in place correctly. Then connect one end of the power
cord to the power port of your device. Finally, connect the
other end to an electric outlet.
STEP 3
STEP 2
DISCLAIMER: This is just a representation of a modem, models and
appearance may vary depending on your Internet provider.
Connect the WAN cable from your modem, switch or
router to the WAN port of your device, with an Ethernet
(RJ-45) cable.
Connect to one of the two LAN ports on your device with
an Ethernet cable (RJ-45) to your equipment or computer
that needs to receive an Internet connection from the
CDS-9010. Your device allows you to connect up to two (2)
devices for Internet access.
STEP 4
Connect the RJ-11 (Phone line) from your phone or
equipment requiring a phone line to the DataRemote
CDS-9010 device’s FXS port.
Do not connect an active RJ-11 with voltage directly from the wall
into the DataRemote device’s RJ-11 ports, this will damage the
device permanently. Each DataRemote device’s RJ-11 FXS port is
an active port supplying voltage. The FXS port is only to be
connected to an FXO analog phone or another FXO device.
WARNING!

Revision No. 005 August 2020
make sure the antennas do not touch each other. If the antennas
touch, your connection may be degraded
Check the Power, WAN, LAN and LEDs lights to make sure
you are connected properly. IMPORTANT: Make sure
antennas don’t touch each other.
Your device should look like this when connected to a
phone line, WAN and one LAN/Computer device.
Make sure the antennas do not touch each other.
STEP 6
Connect the LTE antennas to their respective ports,
making sure the antennas don't touch each other. Please
be aware of the following warning.
STEP 5
WARNING!
WHAT IS ON THE
BACK OF YOUR DEVICE