DataRemote Pots In a Box CDS-9090 User manual

STEP 1
IMPORTANT:
QUICK START GUIDE
CDS-9090
Check the Power, WAN and LAN LEDs lights to make sure
you are connected properly.
Make sure the antennas do not touch each other.
STEP 6
STEP 5
POTS IN A BOX
For more information on
how to configure your
DATAREMOTE
CDS-9090 Device, please visit
Support.DataRemote.com
Then connect one end of the power cord to the power
port of your device, then connect the other end to an
electric outlet.
Make sure the
antennas do not
touch each other,
this will cause the
connection to be
degraded.
WARNING!
STEP 7
!"#$%" &'(%')*+ '$ ,$*-+.%" '/" %$.'"%0 12"(&"
,$**",' 3$.% 4"5)," 63 #$22$7)*+ '/"&" 8&'"1 63
&'"18 4)%",')$*& (& &/$7* 6"2$79 :# 3$. /(5" (*3
;."&')$*& %"+(%4)*+ )*&'(22(')$*0 12"(&" ,$*'(,' 3$.%
<.11$%' ="(>
The SIM card slots are located on the left bottom corner
of your device. Insert the SIM card inside the slot marked
“SIM 1or SIM 2”. Make sure is inserted all the way into the
slot. You will feel aspring lock the SIM card into place.
Connect the antennas to their respective ports (WiFi and
Cell)
Your device should look like this when connected to a
one phone line, WAN and one LAN/computer device.
Finally, with the help of apaperclip or apen, turn
'ON' the ON/OFF button to turn on your device.
!"#$%$&' (&) **3 ,-y .*.*

STEP 4
STEP 3
Connect to one of the four LAN ports on your device with
an Ethernet cable (RJ-45) to your equipment or computer
that needs to receive an Internet connection from the
DataRemote CDS-9090 device. Your device allows you to
connect up to four (4) devices.
Do not connect an active RJ-11 with voltage directly from the wall
into the DataRemote device’s RJ-11 ports, this will damage the
device permanently. Each DataRemote device’s RJ-11 FXS port is
an active port supplying voltage. The FXS port is only to be
connected to an FXO analog phone or another FXO device.
STEP 2
Connect the WAN port of your device to a modem, switch,
router or Internet with an Ethernet cable (RJ-45).
DISCLAIMER: This is just a representation of a modem.
Modem models and appearance may vary
depending on your Internet provider.
WARNING!
WHAT IS ON THE
FRONT OF YOUR DEVICE?
Front panels
LED status
SIM cards slots
ON/OFF
button
Connect the RJ-11 (Phone line) from your phone or
equipment requiring aphone line to the DataRemote
CDS-9090 device’s FXS port programmed for your phone.
Eight (8)
FXS phone line
ports
Four (4)
Ethernet
ports
WAN
Wide Area Network
(Internet)
port
SFP port
(High speed
data transfer)
AC power
cord connector
Wi-Fi antenna connectorsCellular antenna connectors
!"#$%$&' (&) **3 ,-. /*/*