Dateq SPL-EXT3 User manual

SPL-EXT3_204101_V1.0EN
SPL-EXT3
Multi Color Display extension
Manual

Due to the nature of this produ t and it's designed fun tionalities it is onsidered to be used and
installed solely by professional and ertified installers and is not intended for onsumer usage or
resale. Consumer use is not supported by the manufa turer.
SPL-EXT3_204101_V1.0EN

UK DATEQ SPL-EXT3 Manual Safety instru tions 3
Safety instructions
1. All safety instru tions, warnings and operating instru tions must be read first.
2. All warnings on the equipment must be heeded.
3. The operating instru tions must be followed.
4. Keep the operating instru tions for future referen e.
5. The equipment may never be used in the immediate vi inity of water; make sure that water and
damp annot get into the equipment.
6. The equipment may only be installed or fitted in a ordan e with the manufa turers
re ommendations.
7. The equipment must be installed or fitted su h that good ventilation is not obstru ted in any way.
8. The equipment may never be installed in the immediate vi inity of sour es of heat, su h as parts
of heating units, boilers, and other equipment that generates heat (in luding amplifiers).
9. Conne t the equipment to a power supply of the orre t voltage, using only the ables
re ommended by the manufa turer, as spe ified in the operating instru tions and/or shown on
the onne tion side of the equipment.
10.The equipment may only be onne ted to a legally approved earthed mains power supply.
11.The power able or power ord must be positioned su h that it annot be walked on in normal
use, and obje ts that might damage the able or ord annot be pla ed on it or against it. Spe ial
attention must be paid to the point at whi h the able is atta hed to the equipment and where the
able is onne ted to the power supply.
12.Ensure that foreign obje ts and liquids annot get into the equipment.
13.The equipment must be leaned using the method re ommended by the manufa turer.
14.If the equipment is not being used for a prolonged period, the power able or power ord should
be dis onne ted from the power supply.
15.In all ases where there is a risk, following an in ident, that the equipment ould be unsafe, su h
as:
●if the power able or power ord has been damaged
●if foreign obje ts or liquids (in luding water) have entered the equipment
●if the equipment has suffered a fall or the asing has been damaged
if a hange in the performan e of the equipment is noti ed
Appropriately qualified te hni al staff must he k it.
16.The user may not arry out any work on the equipment other than that spe ified in the operating
instru tions.

Index
Safety instru tions..............................................3
Introdu tion........................................................5
Installation..........................................................6
Conne tions...................................................7
Operation...........................................................8
Te hni al spe ifi ations...................................10
Produ t support................................................12

UK DATEQ SPL-EXT3 Manual Introdu tion 5
Introduction
The SPL-EXT3 is a Multi olor extension display that an be linked to the SPL-D3, SPL5 MK2 and
SPL6 limiters. The display will show in green, orange or red the measured sound levels of the
onne ted limiter.
The unit is plug and play ready and only needs the orre t onfiguration in the linked limiter
software.
Product support
For questions about the SPL limiter series, a essories and other produ ts you an onta t:
onta t opnemen met:
DATEQ Audio Technolo ies
De Paal 37
1351 JG Almere
Netherlands
Telephone: +31(0)36 – 5472222
E-mail: [email protected]
Internet: www.dateq.nl

6Installation DATEQ SPL-EXT3 manual UK
Installation
The SPL-EXT3 is installed apart from the audio sour e (a mixing desk for example), the speakers
and amplifier.
Image 2: Installing the SPL-EXT3 connected to the SPL-D3 logger
Image 1: Installing the SPL-EXT3 connected to the SPL5 MK2

UK DATEQ SPL-EXT manual Installation 7
Connections
Ja k 3-pens female
Pin Function Description
SL Ground Data ground
Tip Data TX Data send
Ring Data RX Data re eive
Table 1: Display link onne tions
Link
This is the data onne tion with the optional SPL-D3, SPL-5MK2 or SPL6. For this a stereo 6.3mm
ja k able is required.
Cable link setup for SPL5MK2 and SPL6:
Cable link setup for SPL-D3:

8Operation DATEQ SPL-D3 manual UK
Operation
1. Display 1:
Shows the a tual measured dB value in green, orange or red.
2. Filter weight:
Shows the used filter weight in dBA, dBC or dB (no filter).
3. VU/Redu tion bar:
Shows the a tual fast PPM level in dB.
Linked to the SPL-5MK2 or SPL6 the VU meter an also be used to show sele ted Leq or
redu tion level of the limiter.
4. Displays 2 and 3:
Shows the a tual measured dB value in green, orange or red.
Both displays an be sele ted with an independent value/ filter.
5. Leq/min:
Shows the used time frame for Leq. In this example 10 minutes for display 2 and 60 minutes for
display 3.

UK DATEQ SPL-D3 Manual Operation 9
6. Link:
Link onne tion for data link with SPL-5MK2, SPL6 or SPL-D3.
7. Power:
Power onne tion, 24 volt, advised 1 amp (24 Watt) Normal operation 0.5 amp (12 Watt).
8. VESA 50:
Standard VESA 50 mount for wall mount, M4, max length 12mm.
9. Standard:
Standard mounting bra ket provided with the SPL-EXT3, M4, max length 12mm
10.Safety mount:
M5 DIN s rew for mounting an extra safety able. Max s rew length: 12mm

Technical specifications
Common
Norm
EU: Measurement hain designed to omply a ording spe ifi ations
IEC-61672-1 lass 2
Fran e: Measurement hain designed to omply a ording spe ifi ations
NFS 31-122-1-2017 and de rét 2017-1244
BE: Measurement hain designed to omply a ording spe ifi ations
VLAREM-II Cat.1, Cat.2 and Cat.3
DE: Measurement hain designed to omply a ording spe ifi ations
DIN-61672, DIN-60651 and DIN15905-5
Link
Opti al isolated data proto ol
Power supply
Supply voltage 24 volt
Power usage (max) 24 Watt
Power usage (normal operation) 12 Watt
Dimensions and weight
Front 282mm x 192mm
Depth 55mm
Weight 2.8kg
SPL-EXT3_204101_V1.0EN

Product support
For questions about the SPL series limiters, a essories or other produ ts onta t Dateq at:
Dateq Audio Technolo ies B.V.
De Paal 37 Phone: [phone]
1351 JG Almere E-mail: [e-mail]
The Netherlands Internet: www.dateq.nl