Deco Lighting Agilis DUC-LED User manual

DUC-LED
Agilis Under
Cabinet
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
2917 Vail Ave., Commerce, CA 90040 • (800)613-DECO (3326) • [email protected] www.getdeco.com 1
IMPORTANT SAFETY INSTRUCTIONS
•To reduce the risk of death, personal injury or property damage from re, electric shock, falling parts, cuts/abrasions, and
other hazards please read all warnings and instructions included with and on the xture box and all xture labels.
•Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
•Installation and service of luminaires should be performed by a qualied licensed electrician.
•Maintenance of the luminaires should be performed by person(s) familiar with the luminaires’ construction and operation and
any hazards involved. Regular xture maintenance programs are recommended.
•It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on ambient dirt
level and minimum light output which is acceptable to user. Refractor/lens should be washed in a solution of warm water and
any mild, non-abrasive household detergent, rinsed with clean water and wiped dry. Should optical assembly become dirty on
the inside, wipe refractor/lens and clean in above manner, replacing damaged gaskets as necessary.
•DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have been damaged
during transit. Inspect to conrm. Any part damaged or broken during or after assembly should be replaced.
•Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.
•These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency
to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular
problems arise which are not covered sufciently for the purchaser’s or owner’s purposes, this matter should be referred to
Deco Lighting.
WARNING
• These products may represent a possible shock or re hazard if improperly installed or attached in any way. Products should
be installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC).
• To avoid electrical shock, disconnect or disable power a the source prior to installation or maintenance.
• To avoid electrical shock, and to assure proper operation, this xture must be adequately grounded.
• To avoid electrical shock, use only with 120V AC plug-in power supply or with 120V AC hardwire power supply. Factory
warranty will be void if used with a non-recommended power supply, transformer, or driver.
•To avoid electrical shock, and to assure proper operation, this xture must be adequately grounded.
•12-inch minimum spacing distance from luminaire required for all objects located under xture.
•Linkable total wattage is 200 Watts.

DUC-LED
Agilis Under
Cabinet
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
2917 Vail Ave., Commerce, CA 90040 • (800)613-DECO (3326) • [email protected] www.getdeco.com 2
1. Fix the xture to the unit using
2 xing screws
2. Connect the multiple xtures by snapping the End to End Connector
or Jumper Connector.
4. By ipping the switch (a) select
between one of the 3 modes (Lo,
Off, Hi ).
Switch (b) is used to change the
color temperature of light delivered
3000K, 4000K & 5000K CCT
respectively.
3. Finally wire the power cord to 120v mains supply.
Components
Plug-In Installation
A. Agilis Fixture
B. 1 x 6’ Power Cord
C. Jumper Connector
D. End to End Connector
E. 2 x Screws
F. Romex Connection Kit
A
B
D E F
C

DUC-LED
Agilis Under
Cabinet
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
2917 Vail Ave., Commerce, CA 90040 • (800)613-DECO (3326) • [email protected] www.getdeco.com 3
1. Remove the knock-out by hammering.
3. Insert romex connector into the housing
open hole on the adapter plate. Secure it
with the nut.
5. Connect the Green ground input supply
wire to the xture Green ground wire.
Connect the White input supply wire to the
xture White wire.
Connect the Black input supply wire to the
xture Black wire.
**Do not mix wires or change polarity.
6. Feed wires back into xture, reattach
adapter plate tighten screw, and attach
the xture to the base of the cabinet, with
screws.
4. Pull 3 wires out of the xture to allow
connection to the branch circuit.
Inserting wires into the open hole in the
push-in wire connector.
2. Disengage adapter plate by loosening
screw.
Hardwire Installation