DEEP DRIP 14GKDD User manual

Step 1: Location
Designate your installation location, choose an area
free of underground lines or pipes. We recommend 2-3
Stakes - one on each side of your tree/plant or three in
a triangular pattern. (Fig.1) Smaller flowers or potted
plants may only require one stake.
Step 2: Installation
NEW TREE INSTALLATION: If you are planting a brand
new tree, dig your designated planting area and place
your tree in the center of the hole. Insert stakes just
outside the tree’s root ball, and backfill the area with soil.
No pounding needed!
EXISTING TREE INSTALLATION: Drive the
stakes into the ground using a 3-5 lb. sledge
hammer. Make sure to place the caps on
the stakes when installing them in order
to prevent stake from breaking. Pound the
stakes into the soil until only the top hole
of the stake is above ground. (Fig. 2) Option
2: You can also drill into the ground with an
auger bit to clear pathway and more easily
place the stakes into the ground.
QUICK INSTALLATION STEPS
Deep Drip was specially engineered to water,
fertilize, and aerate your trees and plants, while
conserving up to 50% of your outdoor water use.
Our 4 convenient sizes accommodate everything
from flowers, potted plants, vegetable gardens,
shrubs, vines and new/small to established/large
trees and palms.
NECESSARY EQUIPMENT AND SUPPLIES
• Protective Eyewear
• Gloves (Optional)
• Water Hose
• Soil Softener (Optional)
• 3-5 lbs. Sledge Hammer or Auger Bit (Optional)
Fig. 1 Fig. 2
36”24”14”8”

Step 3: Installation with Drip Line,
Garden Hose or Flood Irrigation
DRIP LINE: Once in the ground, remove cap and insert drip line
emitter in to the stake aligning it with the slot in the cap. (Fig. 3)
GARDEN HOSE/FLOOD
IRRIGATION: When using a
garden hose or flood irrigation,
create a tree berm and fill it up
with water, this allows the water
to enter the stake through the
top hole and travel down to the
roots without having to remove
the stake cap. (Fig. 4)
Tips
If the soil is too dense, pre-wet the area and if needed use soil
softener before installing. You can also remove stake cap and
pour water into the stake with a garden hose, allowing the soil to
become saturated as you install the stake.
Remember, you can add water-soluble fertilizer and/or nutrients
directly into the stake shaft in order to more effectively reach the
roots. Distribute the suggested amount of fertilizer among the
installed number of stakes, and make sure you add water in order
to dilute it’s concentration.
As your tree grows, you can remove the stake
by inserting a screwdriver into the stake’s top
hole and twisting the shaft clockwise as you
pull up. After removing the stake, you can
re-install it just inside your growing tree’s drip
line, also known as canopy. (Fig. 5)
Fig. 5
Additional Information
For more detailed installation
instructions, please visit our
website at www.DeepDrip.com
SCAn For
inStruCtion
video
866.469.4330 | deepdrip.CoM
QUICK INSTALLATION STEPS (CONTINUED)
Fig. 3
Fig. 4