Dell 114-0922 User manual

All-In-One for
Dell OptiPlex SFF
Installation Instructions
Kit P/N: 114-0922 (with cover)
114-1548 (without cover)
Patent(s) Pending

Page 2
Kit Contents
Assembly Components:
(1) Stand Assembly
(1) Dell Monitor Bracket (Attached)
(1) PC Bracket (Attached)
(1) VESA Monitor Bracket
(1) Rear Cover (114-0922 only)
Monitor Hardware Package:
(8) Nylon Spacers
(5) M4 x 10mm Pan Head Screws
(5) M4 x 18mm Pan Head Screws
(5) M4 x 25mm Pan Head Screws
Installation Instructions
Step1 Computer & Cover Installation: Remove the PC Bracket and orient the computer
in the appropriate position on the stand. Remove the 10-32 Truss Head Screw
and attach the cover by hooking it to the top of the computer. Reinstall the Truss
Head Screw to complete the installation of the cover. The computer may need
some adjustment for optimum t of the cover. Install the PC Bracket with the
Thumb Screw to secure the PC on the stand.
Step 2a Monitor Attachment: The Stand will attach to most Dell Monitors; the monitor
attaches similar to Dell's monitor stand using the latch and button on back (no
tools required). If your monitor does not attach or you are using a VESA monitor
continue to Step 2b.
Step 2b Dell Monitor Bracket Removal: If you are using the VESA Monitor Bracket, you
will need to remove the Dell Monitor Bracket by loosening the Thumb Screw and
pivot the bracket away from stand.
SFF Computer
PC Bracket
Thumb Screw
Cover
10-32 Truss Head
Dell Monitor Bracket
Thumb Screw

Page 3
Screws and Spacers are Shown to Scale
Installation Instructions
Step 3. VESA Monitor Bracket Attachment: Turn the monitor face down on a large at
surface. Locate the four VESA mounting holes on the rear of the monitor.
a. Determine if spacers are required: Some monitors have a "recess" on the rear
of the monitor. Spacers are provided to ll this gap. See Table A for spacer
length options.
b. Determine Screw Length: Only use the metric M4 screws provided. The screw
length is determined by the spacers used (see Table A).
(4) Screws, Metric
See Table Below
VESA Monitor Bracket
Spacers
(See Table Below)
VESA Hole Pattern
Recess
Bottom
of Monitor
Recess Depth Spacer Screw
0 No Spacer Needed 10mm
.250 (1/4) 18mm
.500 (1/2) 25mm
Table A

Warranty Statement
Innovation First, Inc. warrants our products against defects in material and workmanship for a
period of one (1) year from the date of purchase. Innovation First, Inc. liability shall be limited to
repairing or replacing, at our option, any defective product.
Installation Instructions
Step 4 Monitor to Stand Installation: Slide the monitor with the VESA Monitor Plate down
over the top two Tabs on the Stand. Tighten the Thumb Screw from step 2.
922
Stand
Tabs
Pivot Bracket
Thumb Screw
Monitor
Monitor
1548