Dell OptiPlex 780-USFF User manual

Dell Computer and Monitor
USFF Wall Mount
Installation Instructions
Kit P/N: 104-1952
Patent(s) Pending

Page 2
Kit Contents
Assembly Components:
(1) Main Bracket
(1) Pivot Assembly
Monitor Hardware Package:
(8) Nylon Spacers
(5) M4 x 10mm Pan Head Screws
(5) M4 x 18mm Pan Head Screws
(5) M4 x 25mm Pan Head Screws
Wall Mount Hardware Package:
(4) Pan Head Screws
(4) Anchors
Pivot Hardware:
(5) 8-32 Flat Head Screws
PC Wall Mount Installation Instructions
Step 1. Determine Location: Select appropriate location on wall. Consider cable routing
and length.
Step 2. Mark Hole Positions: Hold base in position and mark 4 hole positions with pencil.
Step 3a. Install Drywall Anchor: Install one drywall anchor at each hole mark. Using a
#2 Phillips head screwdriver press the anchor into the drywall while turning
clockwise until it is seated ush with the wall.
Step 3b.Install 4 Screws: Leave 1/4" of each screw out of wall.
1/4"

Installation Instructions
Page 3
M4 Screws (4x)
Pivot Assembly
Bottom of Monitor
Outer four holes
= 100mm
Step 4. VESA Monitor Bracket Attachment: Turn the monitor face down on a large at
surface. Locate the four VESA mounting holes on the rear of the monitor.
a. Determine if spacers are required: Some monitors have a "recess" on the rear
surface. Spacers are provided to ll this gap. See Table A for spacer
length options.
b. Determine Screw Length: Only use the metric M4 screws provided. Screw
length is determined by the spacers used (see Table A).
Screws and Spacers are Shown to Scale
Recess Depth Spacer Screw
0 No Spacer Needed 10mm
.250 (1/4) 18mm
.500 (1/2) 25mm
Table A

Warranty Statement
Innovation First, Inc. warrants our products against defects in material and workmanship for a
period of one (1) year from the date of purchase. Innovation First, Inc. liability shall be limited to
repairing or replacing, at our option, any defective product.
Step 6. Computer Attachment: Slide computer into Main Bracket as shown.
Installation Instructions
Step 7. Attach Mount Base: Attach base to wall using the 4 screws that were installed in
3b. Tighten Securely.
Step 5. Assembly: Remove main Bracket if it is attached to the wall before continuing
with this step. The monitor can be mounted at different heights depending on
your application. Mount the monitor assembly through the Main Bracket using the
included screws.
1952
(4) 8-32 Flat
Head Screws