
9
DESCRIPTION
Description of the appliance
(page 3 - A )
A1. Grinding adjustment dial
A2. Main switch
A3. Beans container
A4. Beans container lid
A5. Pre-ground coee funnel lid
A6. Compartment for measure
A7. Cup shelf
A8. Pre-ground coee funnel
A9. Steam spout
A10. Cappuccino maker (removable)
A11. Ring for selection CAPPUCCINO/LATTE
A12. Steam nozzle (removable)
A13. Water tank
A14. Power cable
A15. Cup tray
A16. Drip tray
A17. Infuser door
A18. Coee grounds container
A19. Coee spout (adjustable height)
A20. Coee guide
A21. Infuser
A22. Control panel
A23. Measure
Description of control panel
(page 3 - B )
B1. button: turns the appliance on and o. (stand by).
B2. Temperature OK or 1 cup coee light
B3. button: to make 1 cup of coee
B4. Temperature OK or 2 cup coee light
B5. Tasto : to make 2 cups of coee
B6. Temperature OK for steam light
B7. button: to select the steam function
B8. Coee quantity selection dial (short, standard or long)
B9. Selection dial to choose the coee taste (for a mild,
standard or strong coee) or to use pre-ground coee
.
B10. Steam dial/hot water
B11. light: no water or water tank not inserted
B12. light: grounds container full or missing
B13. light: general alarm
B14. Rinsing or descaling button
B15. Descaling light
B16. ECO energy saving mode button
B17. Energy saving mode light
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged.
Contact Customer Service (see enclosed guarantee leaet).
Installing the appliance
Important!
When you install the appliance, you should follow the following
safety warnings:
• The appliance gives o heat.
After positioning the appliance on the worktop, leave a
space of at least 3 cm between the surfaces of the appli-
ance and the side and rear walls and at least 15 cm above
the coee maker.
• Water penetrating the appliance could cause damage.
Do not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
• Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to the
value indicated on the rating plate on the bottom of the appli-
ance.
Connect the appliance to an eciently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied pro-
fessional.
Using the coee maker for the rst time
Please note:
• Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coee
in the mill.The machine is, however, guaranteed to be new.
• You should customise water hardness as soon as possible
following the instructions in the section “Setting water
hardness”on page 15.
1. Plug the appliance into the mains socket .
2. Remove the water tank, ll to the MAX line with fresh wa-
ter then replace in the appliance (g. 1).