DeLonghi IR 3010 User manual

INFRARED GAS HEATERInstructions
IR 3010

2
Warnings (keep in a safe place) en
GAS LEAKS CAN BE DETECTED BY THE SMELL
The gas heater must ALWAYS be used according to the in-
structions provided with every appliance.
Keep the instructions in a safe place.
DO NOT move the appliance from one room to another
when lit. Knocks or jolts could activate the safety device.
DO NOT position the heater against a wall or near curtains,
etc. ALWAYS position the appliance facing towards the
centre of the room. Pay particular attention when the
heater is standing on surfaces on which it could move
easily if knocked by children, dogs, etc.
DO NOT position the heater near armchairs or fabrics.
DO NOT place clothes or other fabrics on the heater. A re
risk may be run and could jeopardise correct operation of the
appliance.
If you suspect there may be a gas leak, close the gas valve on
the cylinder. DO NOT disconnect the pressure regulator.
To close the gas shut-o the valve on top of the cylinder.
Check all connections. Open the gas slowly and apply soapy
water or liquid detergent to all the ttings. Bubbles will form
if there is a gas leak. If you nd a leak, shut o the gas and
contact a qualied technician. DO NOT use the heater again
until it has been thoroughly inspected by a qualied tech-
nician.
1
3
5
2
4
6

3
INTRODUCTION
Thank you for choosing a De’Longhi product. Please take a
few minutes to read these instructions.This will avoid all risks
and damage to the appliance.
IMPORTANT SAFEGUARDS
- This appliance shall
not be installed
in bedrooms and
bathrooms.
- This is a ueless gas-
red heater. It uses
air (oxygen) from the
room in which it is
installed. Provisions
for adeguate
ventilation shall
be provided. Refer
to the following
instructions.
- Carbon monoxide
poisoning: Early signs of carbon
monoxide poisoning resemble u symptoms, wih
headaches, dizziness or nausea. If you have these
symptoms, the heater may not be working properly. Get
fresh air at once! Have the heater serviced. Some people
are more aected by carbon monoxide than others.
These include pregnant women, people with heart or
lung disease or anaemia, those under the inuence of
alcohol, and those high altitudes.
- The appliance exhausts combustion products into the
room where it is used.
The appliance has to be used therefore only in well
ventilated rooms with two permanent openings
communicating with the outside, each with a minimum
diameter of 12 cm (or in any case no smaller than 105
cm2, in compliance with the relevant local regulations).
The openings must be protected by grilles and located
one near the oor and the other near the ceiling.
- Incaseothergas/solidfuelorparanburningappliances
canbeoperatedinthesame room, additionalventilation
openingneedtobepresentaccordingtoSANS1539:2012
annex D. It’s the installers’s responsbility to ensure the
verication of this requirement.
- Moisture levels inside the room where the appliance
is run can increase. Adequate ventilation of the room
would improve comfort level.
- The appliance MUST NOT be used in top oor ats,
basements, bathrooms, bedrooms or any other room
with a volume of less than 42m3(24m3in the case of
sitting rooms).
- Make sure the appliance is installed in compliance with
current regulations.
- Do not install the appliance in rooms which might
contain gas, petrol or sulphur. Do not install near sources
of heat.
- Do not use on vehicles such as caravans or camper vans.
- The appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
- Respect the following safety distances from the walls:
20 cm from the sides, 150 cm from the front.
- USE THE APPLIANCE ON A FLAT FLOOR ONLY.
- DO NOT REPLACE THE GAS CYLINDER INTHE PRESENCE OF
NAKED FLAMES.
- NEVER USE MATCHES OR NAKED FLAMES TO LOCATE A
GAS LEAK.
- The grille is designed to prevent the risk of re or
burns. None of its components should be permanently
removed. The grille does not guarantee total protection
for children or disabled people.
- Make sure the rear panel protecting the gas cylinder is
correctly in place before lighting the heater. Do not use
the heater without the rear panel.
- The heater must not be used unless the gas cylinder is
Important safeguards en

4
Important safeguards /Technical data/Installation
TECHNICAL DATA
Type Category Low
power
High
power
Medium power
(models without
thermostat
only)
Gas pressure
G30/G31 I3+ KW 1.50
g/h 109
KW 4.20
g/h 305
KW 2.85
g/h 207
28-30 mbar
These appliances are designed to operate with butane/propane gas at a nominal pressure of 28 - 30 mbar. An air ow of 8.4
m3/h is required for correct gas combustion.
INSTALLATION
Hose pressure regulators and clips
MAKE SURE the rubber hose ts perfectly on the hose connec-
tor and is held rmly in place by the hose clips (see g. B).
Check the expiry date and condition of the rubber hose regu-
larly. If damaged or expired, replace with a new 400 mm
hose in compliance with current regulations.
Make sure the hose is correctly inserted in the support (see
g. C).
When connecting the pressure regulator to the gas cylinder,
g. B
g. C
en
correctly positioned in the gas cylinder compartment
(g. A).
Rear panel in the correct
position for use
Gas cylinder
compartment
g. A

5
g. D
g. E
Installation / Use en
make sure the hose is free from bends, twists or constric-
tions.
Installing/replacing the gas cylinder
A cylinder with a capacity of 9 kg is to be used.
The cylinder MUST NOT be replaced in the presence of naked
ames. Always use the gas cylinder in a vertical position only.
To replace it, close the gas shut-o valve on the top of the
cylinder (g. D), remove the rear panel and take the cylinder
out of the compartment.
Unscrew the connection between the regulator and the cylin-
der and remove the regulator. Inspect the gasket carefully
(g. E) and make sure it is in good condition. If in doubt, re-
place.
Connect the new cylinder and close the connection with the
regulator tightly. Open the cylinder valve and make sure there
are no leaks. Close the valve again, position the gas cylinder
in its compartment and replace the rear panel.
Ventilate the rooms
USE IN WELL VENTILATED ROOMS ONLY
The rooms where the heater is used must be adequately
ventilated. This ensures elimination of combustion products
and guarantees air exchange. (See the“Warnings”chapter for
details).
- The heater is tted with safety devices activated if the
appliance malfunctions. If the pilot ame goes out or
the room is poorly ventilated, the safety device shuts o
the ow of gas and the heater shuts o.
If the safety devices are activated, check the ventilation
opening in the room before lighting the heater again.
USE
Operating instructions
(manual version, IR3010)
Lighting the heater
1) Open the gas cylinder
tap.
2) Turn the adjustment dial
to the position,
press down fully for
about 10 seconds (g.
F) .
3) Hold the dial down and
at the same time press
the piezoelectric starter
2-3 times until the
pilot ame lights. When the pilot ame is lit, continue
holding the dial down for a further 20 seconds to allow
the thermocouple to heat up, then release.
4) If the ame shuts o after the dial has been released,
repeat the procedure described above.
5) To select the required power, press the dial down and
turn as follows:
- (low ame) low power,
- (medium ame) medium power,
- (high ame) high power.
Turning the heater o
Important! To turn the heater o, close the gas cylin-
der tap. The appliance is turned o completely only when the
gas cylinder tap is closed. When the dial is released after the
start-up period, it should rise up to the original height.
If this is not the case, turn the gas o and contact customer
services. Under no circumstances use the heater with the dial
forced downwards.
MAINTENANCE
With the appliance o and cold only, dust with a soft damp
cloth. Do not use solvents or abrasive cleaning products.
If the appliance is not used for a long period, cover and store
in a dry dust free place. For technical problems or maintenan-
ce, contact your local authorised customer services.
Maintenance must be performed every 2 to 3 years.
If in doubt, contact your local customer services.
left-hand screw
regulator connection close
(screw)
closeopen
open
(unscrew)
cylinder
valve
Adjustment dial
Selection
indicator
Piezoelectric
starter button
GASKET

De’Longhi Appliances
via Seitz, 47
31100 Treviso Italia
5712110451/12.12_01