2. Install hand shower.
In2ition Installation Instructions
Parts Included
Cleaning of Parts
Delta Faucet warrants to
the owner of this product
that it is free from defects in
materials or workmanship as
listed above from the date of
purchase. For service either
return it to the location where
purchased or return the
product postage prepaid (we
recommend United Parcel
Service) to Alsons Corporation,
3010 W. Mechanic Street,
Hillsdale, Mich. 49242 for
repair or replacement at our
discretion at no charge.This
warranty gives you specific
legal rights. You may also
have other rights that vary
where you reside.
For assistance or problems
with installation: In the U.S.A.
call Toll Free: 1-888-775-3699,
8:00 a.m. to 6:00 p.m.
Eastern Standard Time
Monday - Friday
Limited Lifetime Warranty
Only clean with a mild
non-abrasive detergent and
soft cloth.
Note: Any other cleaning
product not specifically
designed for cleaning plastic
or metal surfaces may damage
the finish.
Shower Head
Hand Shower
3. Insert hand shower into shower head.
a.
The Hand Shower
should be inserted
at an angle so the
tab on the top of
the Hand Shower
fits into the slot in
the Shower Head.
b.
Gently push the
Hand Shower into
the Shower Head.
a.
Place the hose washers into the hose nuts on each
end of the hose.
b.
Connect the ribbed end of the Flexible Hose to the
Shower Head. Connect the other end of the Flexible
Hose to the Hand Shower. All connections should be
able to be made by hand tightening.
Hand
Shower
snaps into
place.
Insert Hand
Shower at an
Angle into the
Shower Head.
• If the Shower Head
moves when
removing the Hand
Shower, tighten the
connection between
the Shower Head
and the Shower Arm.
Flexible Hose
1. Install the shower head.
4. Removing the Hand Shower from the Shower Head.
75580
a.
The Hand Shower
should be removed
at an angle to
release from the
Shower Head.
b.
Once the Hand
Shower is released
from the lower clips
of the Shower Head,
gently pull the Hand
Shower away from
the slot in the upper
portion of the
Shower Head.
Pull the lower
part of the
Hand Shower
away from
the Shower
Head.
Pull the Hand
Shower down,
away from
the slot in the
Shower Head.
Hose Washer
(2)
a.
a.
b.
b.
a.
Make sure to turn off water supply before installing
the diverter.
b.
Remove existing Shower Head from Shower Arm.
c.
Apply Teflon tape to Shower Arm if necessary, to ensure
leak free connection.
d.
Hand tighten the Ball Connector of the Shower Head to
the Shower Arm. (Use pliers if necessary for firm
installation.)
WARNING: Plumbing Codes require that shower heads and hand showers provide a small but continuous flow of water (trickle) when in “PAUSE” mode. Because of this continuous flow, in
certain circumstances pressure variations in the water line and/or changes in the position of shower temperature control handle while in “PAUSE” mode could result in dramatic changes to
the temperature of the water when the shower head or hand shower is returned to the “ON” position.
ALWAYS point the shower head away from yourself when returning to the “ON” position and feel the water with your hand before resuming your shower to ensure the water flow is not
too hot or too cold. DO NOT allow children or others who might not understand this warning to use the “PAUSE” function.
