Depco 301 User manual

300 Series
1-800-767-1062  www.depcoinc.com
301: Corner Unit Instructions
Step 1:
Insert legs into slots in frame.
Note: Welds should be up on steel frame.
Step 2:
Insert (2 3½ bolts into each leg and then place
nuts and washers on bolts.
Note: It may be required to tap bolts through the
holes with a hammer.
Tighten all bolts securely with nuts and washers.
Legs
Frame
Hardware List:
ty. Item
3 Oval Grommets
20 #8 Screws (1½
8 ¼ - 20 x 2¼ Carriage Bolts
4 ¼ - 20 x 3½ Hex Head Bolts
12 ¼ - 20 Hex Nuts
12 ¼ - Washers
Thank you for purchasing your DEPCO Technology
Lab Furniture! If you need further assistance, please
call 1-800-767-1062.
Step 3:
Rotate assembly 180 degrees and place back panel
on with (2 2¼ carriage head bolts. Insert from
back side of back panel. Place nuts and washers
on bolts.
Note: It may be required to tap bolts with a hammer.
Step 4:
Place side panels on using the hole locations and
secure with (6 2¼ carriage head bolts.
Then place nuts and washers on bolts.
Back Panel
Frame
Leg Leg
Legs
Frame
Side Panel
Leg Leg
Back Panel
Frame
Side Panel

300 Series
1-800-767-1062  www.depcoinc.com
We give experiences.
PO Box 176 | 3305 Airport Dr. | Pittsburg, KS 66762 | 1-800-767-1062 | Fax: [phone] | [email protected]
301: Corner Unit Instructions
Step 5:
Place top on securing with 1½ wood screws.
Note: DO NOT over tighten screws or they will strip
out.
Insert Grommets in pre-drilled holes.
Note: Grommets may require tapping with a hammer.
Step 6:
Place corner cap and secure with turn of 2 white
assembly fittings.
Corner Cap
Side Panel
Leg Leg
Back Panel
Frame
Side Panel
Top
Grommet