Ethnicraft SPINDLE BED - QUEEN SIZE User manual

IN YOUR PACKAGE :
ASSEMBLY INSTRUCTION
HARDWARE (AS LISTED ABOVE)
NOTICE
X3
PARTS TO BE INSTALLED
1) HEADBOARD 1 piece
2) SIDERAIL 2 pieces
3) FOOTBOARD 1 piece
4) CENTER SUPPORT 1 piece
5) CENTER LEG 1 piece
6) HEADBOARD PANEL 1piece
SCREWDRIVER
TOOLS
L KEY
( Included in package )
HARDWARE ENCLOSED
SYMBOLS
DIRECTION NUMBER OF
PERSONS NEEDED
USE SCREWDRIVER
TO TIGHTEN
USE L KEY
TO TIGHTEN
USE HAND
SPINDLE BED - QUEEN SIZE
ASSEMBLY INSTRUCTION FOR BED INSTALLATION
BOLT KEY
( Included in package )
USE WRENCH
TO TIGHTEN
WRENCH
USE BOLT KEY
TO TIGHTEN
(Included in package)
SMB NASE LY I N STRUC TIO
(Not included in package)
HALF MOON
WASHER
4pcs
BOLT
M8x100 mm
4pcs
DOWEL
8pcs
Ø12x50 mm
JCBC BOLT
M6x70 mm
3pcs
WASHER
M6
6pcs
L BRACKET
8pcs
LONG NUT
M6
2pcs
JCBC SCREW
M6x6mm
8pcs
JF SCREW
M6x50mm
5pcs
NUT
M6
4pcs
1
2
2
4
3
(L)
(R)
6
5
SPRING WASHER
M6
2pcs
1/4

A. CONNECTING SIDERAIL-HEADBOARD-FOOTBOARD
B. CONNECTING CENTER SUPPORTCENTER LEG TO
1
2
(L)
DO NOT FULLY TIGHTEN
2
3
(R)
- USE DOWEL (8X)
- USE BOLT M8x100mm (4X)
- USE HALF MOON WASHER (4X)
- TIGHTEN FULLY ALL SCREWS
Ø12x50mm
3
1 2
4
5
- USE JF SCREW M6x50mm (1X)
- TIGHTEN FULLY
1 2
3
SPINDLE BED - QUEEN SIZE
ASSEMBLY INSTRUCTION FOR BED INSTALLATION
2/4

C. INSTALLING CENTER SUPPORT
D. INSTALLING L BRACKET
1
2
- USE JCBC SCREW M6x6mm (6X)
- TIGHTEN FULLY ALL SCREWS
- INSTALLING L BRACKET AT THE SAME
LEVEL WITH CENTER SUPPORT
3
1 2
TO ADJUST HEIGHT
4
- USE JCBC SCREW M6x6mm (2X)
- USE JF SCREW M6x50mm (4X)
- USE WASHER M6 (4X)
- USE NUT M6 (4X)
- TIGHTEN FULLY ALL SCREWS
SPINDLE BED - QUEEN SIZE
ASSEMBLY INSTRUCTION FOR BED INSTALLATION
3/4

F. FINISH
E. INSTALLING HEADBOARD PANEL
- USE JCBC SCREW M6x70mm (1X)
- TIGHTEN FULLY
1 2
6
- USE JCBC SCREW M6x70mm (2X)
- USE LONG NUT M6 (2X)
- USE WASHER M6 (2X)
- TIGHTEN FULLY ALL SCREWS
- USE SPRING WASHER M6 (2X)
1
2
SPINDLE BED - QUEEN SIZE
ASSEMBLY INSTRUCTION FOR BED INSTALLATION
4/4