DeRoyal Safety-Auto Reset M2100-SL Reference guide
Safety-Auto Reset
Fall Monitor
M2100-SL
QUICK REFERENCE CARD
Warning: Failure to comply with warning may result in injury
or death. This device is not suitable for all individuals. Other
devices may be required.This device is not a substitute for
visual monitoring by caregiver. Sensor pad fall monitors are
prone to diculties. Be sure cord cannot entangle or choke the
user.The manufacturer does not claim that this device will
stop elopement and/or stop falls. This device is designed to
agument caregivers comprehensive resident mobility
management program. Test this device before each use.
Read the instructions and legal disclaimer.
Read Instructions Before Use:
Battery not included. Use 3 x AA alkaline Batteries.
Set Up: Plug sensor pad into the fall monitor. Apply pressure to
the sensor pad to test the system. The monitor will emit two
beeps, indicating that the system is working. The Monitor
Status LED will blink every 3 seconds when the system is
activated and operating properly.
Delay
2sec 1sec 0sec3 2 1 Decrease/Increase
Volume
Tone
Safety Auto Reset™
Pad
Lost
Low
Battery
Monitor Status
Active When Blinking
Pad and Monitor
Reset
CAREGIVER KEY™
RESET BUTTON
TONE
3 Options
VOLUME DELAY
3 Options
QUICK STEPS
SETTING UP
WARNING: Be sure to read all alarm and sensor instructions before use. Test system
to ensure that it is working properly before leaving the patient unattended.
NOTE: Patient can reset fall monitor by sitting/laying down
on sensor pad.
RESETTING (Two Options)
1. Connect monitor to pad.*
2. Put pressure on the pad.
3. Wait to hear two beeps.
Select either
“Reset Button ON” or
“Reset Button OFF”
1. If “Reset Button ON”, use the reset button.
2. If “Reset Button OFF”, use the Caregiver Key™.
* Pinch the cord together
and route it through the
strain relief recess.
Refer to User Instructions
before changing this setting.
Reset Button-
ON
Reset Button OFF
Use Caregiver Key
ToTurn OFF
6V DC
300mA MAX
-
Safety Auto Reset™
Pad
Lost
Low
Battery
Monitor Status
Active When Blinking
Pad and Monitor
Reset
DeRoyal Industries | 200 DeBusk Lane | Powell, TN 37849
888.938.7828 | 865.938.7828 | www.deroyal.com
Rev 01/18 | Reprint # 0-2427
DeRoyal, DeRoyal logo, Improving Care. Improving Business., are
registered trademarks of DeRoyal Industries, Inc.
Caregiver Key, Safety Auto-Reset and Tamper Proof
are trademarks of The Smart Caregiver Corporation.
Copyright© 2018, DeRoyal. All rights reserved.
