Deteknix Wire-Free W3 User manual
Congratulations on your purchase of this Wire-Free
wireless head- phones kit. Before using your headphones
for the first time, please take a moment to carefully read
the following information.
Safety Instructions
•When wear the headphones, make sure the volume is
turned to mini- mum. Only adjust the volume after putting
the headphones on. Do not turn the volume up too loud. You
could cause permanent damage to your hearing.
•Danger to life! Headphones dramatically reduce your ability
to hear ambient noise. Using headphones while in road
traffic is potentially very dangerous and is therefore
prohibited by law.Also, please make sure that you do not use
your headphones when in the vicinity of possibly dangerous
machines and tools.
Content
One lite headphone, one adopter , one USB 2.0 charger cable,
one magnetic charger cable, two elastic bands, two iron
pieces, one carry bag
Headphone Adjustment
Before wearing the Wire-Free lite headphone for the first time
you should adjust it properly to achieve the best sound and
ambient noise attenuation.
Unfold the headphone pad as the figure 1. and 2. Select the
appropriate lock-in position on both sides of the headband as
figure 3.The pads will adjust the angle automatically
according to your head size.
1
2 3
Power on transmitter
Make sure the transmitter is fully charged and press the power
button for 1 second.The LED indicator will start to flashing.
Pairing transmitter with headphone
Place the headphone close to the transmitter in less than 10CM,
press and release the power button of headphone quickly. The
LED indicator of transmitter will turns to steady condition.
Power on headphone
Make sure the transmitter is fully charged and press the power
button(between two volume button) for 1 second.The LED
indicator will start to flashing.
Power on transmitter
Make sure the transmitter is fully charged and press the power
button for 1 second.The LED indicator will start to flashing.
Attach transmitter to your detector
We provide two methods to attach the transmitter to your detectors.
For headphone jack on control box, you can clip it on the rod by
elastic band. For headphone jack under the arm-rest, you can paste
the iron piece on flat place and attach the transmitter on it.
Now you have turned your detector into wireless!
Transmitter recharging
You can recharge it thru laptop computer USB port,
smartphone charger or power bank.
Plug the USB side into the port and place the magnet head on
the transmitter’s charging place.
The LED indicator will start to flashing. It will turns off when
fully charged.
Headphone recharging
You can also charge the headphone thru the USB 2.0 cable by
computer, smartphone charger or portable power bank.
This manual suits for next models
2
