Dewenwils HOYS16F User manual

HOYS16F
Outdoor Remote Control
Yard Stake Outlet

WARNING :
To reduce the risk of fire, electric shock or personal injury,
please strictly follow the instructions.
1. Do not connect any devices which exceed the maximum ratings of
tthe yard stake.
2. Do not immerse in water.
3. Children are not allowed to use the yard stake without supervision.
4. Do not disassemble or repair the product, but only by authorized
service personnel.
5. Always unplug and store indoors when not in use.
Installation

As shown in the figure, connect the three sections together. Be sure to
firmly tighten the stake to the body before installing into the ground.
Tips：If the ground is too hard to insert the stake, digging a hole that
matches the stake with a hard object will be perfect.
1.Power Light
2.Overload Protection Switch：
Turn on/off the power manually and
overload protection.
3.Manual Switch：
Turn on/off the power manually.
4.Transmitter:Turn on/off the power
manually.
Press the overload protection switch to the“I”position and turn
on all outlets first. The indicator on the switch will be lighted.
The yard stake outlet can be operated via the included transmitter
from up to 100ft away or manually turned ON/OFF by press the button on
the back of the outlet.
Product Layout
Operating Instructions
1
2
3
4
Manual

3
●Ensure the switch is in" I" position.
●Press the ON button to turn all 6 outlets on the yard stake ON.
The ON LED indicator should light up.
●Press the OFF button to turn all 6 outlets on the yard stake OFF.
The ON LED indicator should turn off.
Notes:The receiver must be located within 100 feet from the remote
transmitter. Actual function range may be affected by the
following factors: weather, radio frequency interference, low
remote battery and obstructions between the transmitter and
receiver.
Control by Transmitter:
1. Press the manual button on the back of the yard stake to turn all outlets
on-Always ON.
2. Press the manual button again, and all settings will turn off. No power
for any outlet.
The On LED indicator will be off when the switch is in Off mode.
**Remember to press the switch to " I" position for transmitter operating
next time.
Control by Receiver (Manual Button) :
The unit has a reset function for overload protection. If the power
turns off unexpectedly, please unplug all devices, press the power
switch (resets device ) and reconnect devices.
Overload Protection
●RF (radio frequency) transmitter is powered by one 3V (CR2032)
lithium battery.
●Red indicator light Flickers when transmitting.
●Remote operates the receiver ON/OFF.
●Replace battery when red indicator light does not flicker when a button
is pressed.
Remote control unit

4
Specifications
●Install the battery observing the
positive (+) side up as indicated
inside the battery compartment.
●Never throw batteries into a fire. Do not expose batteries to fire or other
heat sources.
●Battery contains mercury. Do not put in trash. Recycle or manage as
hazardous waste.
●Remove the battery compartment cover away from the remote (see
diagram below)
●Remove the old battery and place a new Type 3V (CR2032) lithium
battery into the battery compartment.
●Ensure the battery is installed correctly with the positive (+) side up.
●Replace the battery compartment cover.
●Dispose or recycle spent/discharged batteries in compliance with all
applicable laws.
For detailed information, contact your local solid waste authority.
Replacing the battery
Battery Handing and Usage
CR2032
3V
Input Voltage:
- 125V, 60Hz.
Max Power Rating:
- 15A 125Vac 60Hz; 1875W.
Cord:
- 10FT SJTW 14/3 AWG.
RECEIVER MODEL:SP-041
TRANSMITTER MODEL: TR-026A
FCC ID: PAGTR-026A

Caution: Failure to properly align the battery polarity can cause
personal injury and/or property damage.
5
CR2032
3V
CAUTION: There is a risk of fire when too much power is drawn from
this item. Use only with a total of 15 ampere maximum Christmas tree
or other seasonal lighting products.
Do not ingest the battery, Chemical Burn Hazard (The remote control
supplied with) This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal burns
in just 2 hours and can lead to death. Keep new and used batteries
away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children. If you think
batteries might have been swallowed or placed inside any part of the body,
seek immediate medical attention.
●Risk of Fire, Not for permanent installation. Use only with outdoor
equipment, Christmas-tree,other seasonal decorative lighting products
having a total of 15 Ampere maximum. Do not install or use this product
for more than a 90-day period.
●If using Christmas tree or decorative. lighting products that are
not marked with an ampere rating, connect no more than 140
screw base lamps (C7 or C9) or 12 strings with midget (push-in)
lamps to this cord set.
●Cord sets shall be plugged into a GFCI - protected receptacle.
Disregarding cautions could cause damage, fire, or fatal shock.
When using outdoor electrical products, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and personal
injury.
WARNING:
WARNING:
Safety Information
1

6
●If using an outdoor-use cord set for an extended period of time
(greater than 90 days) please consider hard wiring a permanent
outdoor-use receptacle rated for yearround use in the area that
power is needed. Please contact a Licensed electrician for proper
installation of permanent wiring.
●After completion of nstallation, the connector shall be maintained
a minimum of 6 inches above ground.
●For temporary outdoor use - not to exceed 90 days; store indoors
after use. This is not a surge protector. Do not overload the outlet
(maximum: 15 amp, 1875 watts). Be sure to plug the power strip
into a 125 volt GFCI rated receptacle. Do not coil the power cord
when in service. Never use frayed or damaged cord.
● SUITABLE FOR INDOOR/OUTDOOR USE - STORE INDOORS WHILE
NOT IN USE.
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and the receiver.
● Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
● Consult the dealer or an experienced radio/ TV technician for help.
This device complies with Part 15 of the FCC Rules Operation is subject
to the following two conditions:(1)This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation of the device.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.

7
●The receiver doesn't turn on- Make sure the AC power cord is securely
plugged into an AC power outlet. Unplug the unit for a moment and then
plug it back in again. Check the outlet by plugging in another device.
●The remote doesn't work- Make sure the battery is fresh. Make sure the
transmitter and the receivers are set to the same channel. Stand closer to
the receiver, the range should be up to 100 ft. (30.4 m). Doors or walls will
reduce the remote distance.
●In case of overloading, your unit is equipped with a circuit breaker which
will shut off all power. Eliminate overload and then push-to reset circuit
breaker for overload protection.
Trouble Shooting