SOMFY Telis 1 Soliris RTS Pure User manual

SOMFY INSTRUCTIONS
TELIS 1 SOLIRIS RTS
REMOTE CONTROLS
Part #’s
1810635 Telis 1 Soliris RTS Pure
1810647 Telis 1 Soliris RTS Patio
Programming
Button
BACK
my
Sun/Wind
Selector
Telis 1
Wind
Only
Sun
& Wind
© Copyright Somfy Systems, Inc. 1/2010 C - 0003
1. Using a paper clip, pen or similar device,
press and hold the Programming Button on
the back of your current remote until your
window shade jogs up and down.
PROGRAMMING - ADDING A NEW REMOTE
3. Using a paper clip, pen or similar device,
press and hold the Programming Button
on the back of your new remote. The
window shade will jog. This remote will
now operate your shade or awning.
2. Pick up your new remote.
Programming
Button
Programming
Button
BACK
PAGE 1 REV 3
PROGRAMMING - SETTING FAVORITE ‘MY’ POSITION
1. Using the up ( ) or down ( )
buttons, bring the shade or awning
to your favorite position, for example
halfway down or out. Press the
center ( ) button to stop movement
at the desired location.
BACK
my
Pen
Pen
my
Pen
my
3. To reach your favorite position,
press the center ( ) button
whenever the shade is already
stopped. The shade or awning
will automatically go to that
position.
2. Press and hold the center ( )
button until the window shade
jogs up and then down to record
the position.
my

NOTE: Wind sensor is factory set and does not require activation.
1. Press and hold the Sun/Wind
Selector Button.
2. The light will change sides and the
shade will jog. When the left side is lit,
the shade or awning will only react to
wind control. When the right side is lit,
the shade or awning will react to both
sun and wind control.
Sun/Wind
Selector
Wind-only
Sun &
Wind
© Copyright Somfy Systems, Inc. 1/2010
NOTE: IN CASE OF A LOST TRANSMITTER, PROFESSIONAL PROGRAMMING ASSISTANCE IS REQUIRED.
PLEASE CONTACT SOMFY AT [e-mail] OR YOUR LOCAL DEALER
AT www.somfysystems.com/locatedealer.
REPLACING THE BATTERY
1. Using a small screwdriver loosen the
screws on the reverse side of the remote
control and remove the back cover.
2. Replace the battery with one
2430 Lithium 3V battery.
ACTIVATING SUN MODE: REQUIRES OPTIONAL SUN AND/OR WIND SENSOR
Sun/Wind
Selector
C - 0003
my
2. To lower your window shade or
extend your awning, simply press
the down ( ) button.
3. If you want to stop your shade or
awning while it is moving, press the
center ( ) button.
PAGE 2 REV 3
OPERATING
1. To raise your window shade or
retract your awning, simply
press the up ( ) button.