DGS Retail APTE3 User manual

Copyright © 2022 DGS Retail
[phone] Press 2
APTE3 PRODUCE TABLE
F0440

Copyright © 2022 DGS Retail
Part List:

1
2
Copyright © 2022 DGS Retail
PREPARE FRAME FOR ASSEMBLY:
ASSEMBLE BACK BUMPER PANEL:
- Remove parts from the package and set them aside, check content
of the package and parts for any damage, each package
contains parts for one table.
- Set frame vertically with front hinges at top.
- Open leg frames so that the table rests securely on the floor.
- Slide one of the metal bumper panels under the bottom legs, and align holes in
bumper short flanges with holes in L-brackets.
- Attach bumper panel to bottom/ back legs with (4x) 1/4-20 x .625 machine screws.
(x4)
IMPORTANT:
DO NOT CUT ZIP TIES
HOLDING SUPPORT ARMS
UNTIL STEP 9
!

- Attach wood trim panel to the front of metal bumper
panel with (6x) #8-32 x 0.375 machine screws.
- Attach bumper to wood trim with
(4x) #8 x .375 wood screws.
ASSEMBLE FRONT BUMPER PANEL WITH
WOOD TRIM AND BUMPER:
4ASSEMBLE FRONT BUMPER PANEL WITH TABLE:
- Flip the table so that the already installed back bumper panel is located on top.
- Attach bumper panel to front legs with (4x) 1/4-20 x .625 machine screws.
(X4)
3
(X6)
(x4)

5ASSEMBLE LOWER LEG
- Flip the table and place it on its top with leg tubes pointing up.
- Slide the lower leg into tube and align the hole in leg
with one of the holes in tube
- Lock required position of leg in frame with a clevis pin and
secure the pin from sliding out by closing the retaining wire.
- Repeat step for remaining legs, make sure that all legs
have the same length.
6ASSEMBLE LEG CROSSBARS
- Slide the crossbar tube between side legs and attach it
to legs with (2x) 1/4-20 x 1.750 machine screws.
- Repeat the same operations for second crossbar.
(x4)
CLOSE THE
RETAINING WIRE

7ASSEMBLE CASTERS
- Screw in casters into weld nuts on legs, install casters with brakes across front of the table.
8ASSEMBLE FRONT LIP Z-CHANNEL
- Flip table upside-down and set it on casters.
- Slide the z-channel on top front tube, make sure that holes on channel
are aligned with rivet-nuts on the back of tube.
- Attach channel to tube with (5x) #10-24 x 0.500 machine screws.
(x5)
FRONT OF
TABLE

9SET THE TABLE TOP AT REQUIRED ANGLE:
- Remove/ cut-off the zip ties that hold two support arms attached to side tubes.
- Lift the back of the top frame of table and swing down both left and right support arms.
- Depending on the required angle of the top, engage/ rest the appropriate cut-out on support
arms on short side tubes.
- Table top can be set/ adjusted at 0, 15, 25, and 35 degrees.
10 ASSEMBLE PLASTIC TOP PANEL:
- Place the plastic panel with magnetic strips on top of frame, ensure that front of panel
(portion without magnets) is located over front Z-channel and magnets rest on tubes.

ASSEMBLY
COMPLETE
33˝30˝27˝
(REFERENCE STEP 5)
(REFERENCE STEP 9)
42.25˝48˝53.36˝