Diamond Multimedia VS600 User manual

The VS600 wireless extender includes a transmitter and a receiver, allows
to transmit and extend HDMI signal up to 100 meters/328ft (outdoor
space without interference), it has strong anti-interference ability by
running at 5GHz operation frequency. It supports one to one connection,
one to two connection and two to two connection (Second receiver sold separately)
With both remote control and button control, makes channel setting easily. Best solution for
transmitting one or two HDMI source signal to one or two screens in long distance without laying
cables, perfect for conference room, home entertainment and educational applications.
Note：
1) Transmission distance will vary due to the environment.
2) Transmission distance will vary due to the configuration. (Sending from one to two receivers
shortens the transmission distance by almost half.
3) Wall, brick or glass will shorten the signal cover range or cause big
signal loss.
4) It is recommended that the distance between each unit should be
more than 15 feet.

FEATURES
1. Metal housing, stable and durable.
2. Transmitter support one HDMI loop-through
3. Support resolution up to 1080p@60Hz.
4. 300ft long range transmission line of sight. (1 to 1:300ft, 1 to 2:150ft)
5. Support IR passthrough with 20-60KHz frequency.
6. Strong anti-interference 5GHz operation frequency.
7. Support point to point configuration, one to two configuration and 2 to 2 configuration.
8. Support button control and remote control to set channel.

Connection Instruction
1）Connect HDMI input with HDMI source device and connect IR blaster
extension cable with IR OUT interface of the transmitter. Align the
infrared blaster with the source device. (IR is optional)
2）Connect HDMI output with HDMI display device and connect IR
receiver extension cable with IR IN interface of the receiver. Point the
infrared receiver towards the user for best performance
3）Plug the power supply into the device to get started.
4）Set the devices that need to be paired to the same channel.
Note:
1) When the wireless signal transmits through wall, glass or other
obstacles, it will cause signal loss. Please install this device in good
environment with few obstacles.
2) It is recommended that the same space should not exceed two groups
of devices working at the same time. Please keep the distance between
each group of devices greater than 5 meters when using, and the two
groups of devices need to be set to different frequencies to prevent
interference. Please set the channel number of the first group of devices

to 0~4; set the channel number of the second group of devices to 5~9.
3) The environment wireless signal will affect transmission, such as
microwave, wireless mouse and wireless keyboard etc.
FAQ
Q: Transmitter and receiver can't be connected with each other?
A: 1) Please check and make sure both transmitter and receiver have been
powered on and are set for the same channel
Q: The Wi-Fi LED indicator of the transmitter keeps on, but no signal output on display/monitor?
A: 1) Please check if there is an HDMI signal input of transmitter
2)Try to connect the signal source directly to display device to see if
there is signal output from source device or change the signal
source, HDMI cables and try again.
Q: Display not fluent and stable?
A: 1) Please move the position of transmitter and receiver and confirm that the device is within
the signal coverage.
2)Press "reset" bottom on the TX/RX panel, reset and reconnect.
3)Remove other wireless signal disturbance and reduce the obstacle on the way.

Support Options:
Phone: [phone]
Online: Live Chat and ticket submission www.diamondmm.com