digi-tech QP2350 User manual

Handheld
Underwater
Metal Detector
QP2350
Model:
Instruction Manual

1
PRODUCT FEATURES
BATTERY INSTALLATION
• Vibration & light - When a target is located the detector alarms with pulses of
vibration and flashes of bright light from a white LED.
• Target distancing - As you get closer to the target the vibration and light will
increase in quantity.
• Automatic tuning - Requires no adjustment.
• Waterproof - Sealed design allows hunting in the rain or in water.
To open the battery compartment, rotate the battery cover counter-clockwise.
Connect a standard 9 volt alkaline battery to the battery connector and insert the
battery into the detector. Then turn the battery cover clockwise until hand tight to
assure a water-tight seal.

2
OPERATING INSTRUCTIONS
DETECTING A TARGET
HELPFUL HINTS
• You have to hold the detector with coil down to start detection after turn on.
If you continue to hold the detector with the coil up, the detector will not start
operation.
• You can secure the detector to your wrist using the attached wrist strap.
• Before submerging the detector make sure the battery compartment seal is
secure.
• Always use high quality batteries such as alkaline or nickel metal hydride
(NiMH).
Turn on the detector: Hold unit with the search coil up for about three seconds. Light
will flash four times first and the other two flashes will occur simultaneously with
short pulses of vibration and a steady dim light indicate unit is on.
Turn off the detector: After use, hold unit with the search coil up for about three
seconds. Light will flash four times first and the other two flashes will occur
simultaneously with short pulses of vibration and no light indicate the unit is off.
Note: If no metal is detected within one minute, the unit will automatically turn off.
Low battery turn off: When the battery is low the unit will shut down automatically
indicated by four long pulses of vibration and bright light.
After turning on the detector, hold it with coil down to start detection. When target is
located, the detector indicates with vibration and bright light. These pulses increase
in quantity as the closer the search coil is to a detected target. The quantity of
pulses is proportional to the target size and distance. The bigger the target, or the
closer the search coil is to the target, the higher the pulse count. Movement of the
search coil is required to detect a target. Sweep the search coil back and forth along
the surface you are searching. Move the coil slightly away and then re-approach the
target to get the next detection.

Distributed by:
Electus Distribution Pty Ltd
46 Eastern Creek Dr,
Eastern Creek NSW 2766 Australia
Ph 1300 738 555
Int’l [phone]
Fax [phone]
www.electusdistribution.com.au
Made in China
IMPORTANT NOTES
• The detection field projected resembles an oval shape, with the deepest depth
of detection in the center of the coil.
• Raising the detector’s coil up while in use will start the turn-off sequence,
indicated by a blinking light and vibration. Lower the detector’s coil within 3
seconds to continue detecting.
• Unit will not detect when the light is blinking in either the turn-on or turn-off
sequence.
• As with any new detector you should practice with known targets to develop
your searching technique.