Digimerge DH100 Series User guide

1
DH100 Series Touch Screen Monitor Setup
DH100 SERIES TOUCH SCREEN MONITOR SETUP
The DH100 Series DVRs can be controlled with a touch screen monitor (not included). Touch
screen monitors must be Windows 7® Touch compatible to work with the system.
NOTE: A firmware upgrade may be required to enable touch screen compatibility. Firmware upgrades
are available as a free download from www.digimerge.com.
Step 1 of 3: Connect the Cables
The USB cable must be connected to the monitor’s USB port 
and the DVR’s USB port to enable the touch screen function.
USB Port
Power Port
AC power cord
VGA cable
8-channel model shown
USB cable
USB Cable: Enables the DVR to recognize touch gestures on the monitor.
VGA Cable: Transmits video from the DVR to the touch screen monitor.
AC Power Cord: Provides power to the touch screen monitor.
VGA Port

2
DH100 Series Touch Screen Monitor Setup
Step 2 of 3: Power on the Monitor
Step 3 of 3: Test the Touch Screen Functions
Access Quick Menu
• While in viewing mode, press and hold anywhere on the screen for 2 or more seconds. Then
remove your finger to open the Quick Menu.
Navigate Menus
• Tap to select menu options.
• To exit menus, press and hold anywhere on the screen for 2 or more seconds. Then remove
your finger. If you have made any setting changes, you will be asked if you want to save changes.
Select Split Screen View
Quick Menu (8-channel model shown)
Full-screen mode
Split-screen view
selectors
Playback mode
• In the Quick Menu, tap one of the
Split-screen view selectors to open
split-screen view.
Select Channels in Full Screen
• While in a split-screen display mode,
double tap on a channel to view it in full
screen. Double tap again to return to
split-screen display mode.
Access Playback Mode
• In the Quick Menu, tap to enter
Playback Mode.
• Tap the on-screen controls to control
video playback.
• To exit Playback Mode and return to
viewing, press and hold anywhere on
the screen for 2 or more seconds. Then
remove your finger.
Before you start:
1. Make sure your monitor is turned on.
2. Power on your DVR.
3. Wait for the DVR to boot into the main viewing mode.