Displays2go QPMSSBKSM User manual

Assembly Instructions
QUEUE POLE SLATWALL
MERCHANDISERS
Small Metal Slatwall Shelf (QPMSSBKSM)
Large Metal Slatwall Shelf (QPMSSBKLG)
Small Metal Slatwall Basket (QPMSBSLVSM)
Large Metal Slatwall Basket (QPMSBSLVLG)
Accessories sold separately.
Scan the QR
code to visit the
product page.

Large Metal Slatwall Shelf Small Metal Slatwall Shelf Metal Wire Basket
Accessories (Sold Separately)
Base Kit
A. Slatwall panel B. Connectors C. Stanchions D. Hex Wrench
(5mm)
Packing List
Read and understand all instructions prior to assembly to avoid personal or product damage. Carefully insert all
accessories at the correct angle to the slatwall panel to avoid scratches.
Cleaning and Maintenance
• Clean the surface with a soap-based cleaning agent diluted in water, then wipe dry with a soft, dry cloth.
• Powder coated metal is a durable material, but can be sensitive to oxidisation, which can lead to scratching. Be
careful when using hard, warm, or sharp objects as they can damage the surface.
Suggested Weight Capacity per Item
• QPMSSBKLG Large Metal Slatwall Shelf 11 x 49 44LBS (20KGS)
• QPMSSBKSM Small Metal Slatwall Shelf 11 x 23 17.5LBS (8KGS)
• QPMSBSLVSM Small Metal Slatwall Basket 12 x 12 35LBS (16KGS)
• QPMSBSLVLG Large Metal Slatwall Basket 12 x 24 35LBS (16KGS)
Safety Warnings and Precautions

NOTE: Pencil and ruler required for assembly (not included).
Assembly
1. Measure 5 inches from the top of each
stanchion post (C) and mark location with
pencil.
2. Attach connector (B) to stanchion posts.
NOTE: the bottom of the connector should
be above pencil line.
3. Check that connectors are level on stanchion
post and with each other. Tighten with hex
wrench.
4. Carefully lift slat wall and orient to correct
position, shown below.
Slat Wall Orientation

If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
5. Attach slat wall to stanchions by inserting fixing
pins of slat wall into corresponding connector slots.
Hand-tighten to secure.
6. Add 2 connectors to the bottom of the stanchion,
aligning with the fixing pins of the slat wall, then
hand-tighten to secure.
7. Tighten all connectors with hex wrench.
8. Attach any accessories (sold separately) by tilting
and gently sliding into the slats.
Assembly is complete.